608664
171
Zoom out
Zoom in
Previous page
1/588
Next page
14 TROUBLESHOOTING
Problem Probable cause Remedy
1. The starter motor does not
turn.
Battery not charged enough. Recharge the at battery.
Battery not connected. Check the connections.
Fuse 20A blown. Replace the fuse
2. The starter motor turns but
the engine doesn't start.
With the ignition key in the
start position, the starter
motor turns but the engine
doesn't start.
Fuel cock closed. Open the fuel cock.
No fuel ow. - Check the fuel level in the tank.
- Check the fuel lter.
Ignition fault. - Check the spark plug cap is
securely in place.
- Check the spark gap and that
the electrodes are clean.

or engine runs irregularly.
Carburettor problems. Clean or replace the air lter.
4. Drop in engine performance
during cutting.
Forward speed too high in rela-
tion to the cutting height.
Reduce the forward speed and/
or raise the cutting height.
5. The engine stops for no
apparent reason.
- Fuel tank empty.
- Try to restart the engine.
Fill the fuel tank (if the problem
persists, contact an authorised
assistance centre).
6. Uneven cutting. Check the tyre pressure.
The cutting means sharpness
level is low.
Contact an authorised assistan-
ce centre.
Forward speed too high in
relation to the height of the grass
being cut.
Reduce the forward speed and/
or raise the cutting height.
The cutting means assembly is
full of grass.
- Wait for the grass to dry.
- Clean the cutting means assembly.
7. Abnormal vibration during
use.
- Unbalanced cutting means.
- Slackened cutting means.
- loose components.
- possible damage.
Contact an authorised assistan-
ce centre for inspection, replace-
ment or repair operations.
8. With the engine running,
activation of the traction pedal
does not move the machine.
"Disengage transmission” lever in
the disengaged position.
Engage the transmission.
If any of the faults listed below occurs, replace the relevant fuse (22).
9. The engine does not start or
starts and stops immediately.
The battery is charged.
Fuse 10A blown. Replace fuse 10A.
EN
ENGLISH
(Translation of the Original Instructions)
25
171


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiga 740 WX - P 901 CH at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiga 740 WX - P 901 CH in the language / languages: All languages as an attachment in your email.

The manual is 110,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info