742495
18
Zoom out
Zoom in
Previous page
1/56
Next page
OPERATION
Cleaning, care and maintenance
18 | BHE Classic www.stiebel-eltron.com
Position the contact pieces with one at each end of the re-
quired setting range.
Replace the temperature selector.
5. Cleaning, care and maintenance
Note
Avoid abrasive or corrosive cleaning products.
Clean the surfaces when cold with a soft cloth and ordinary clean-
ing products.
BHE 175 T Classic: Clean the air intake and discharge apertures
of the rapid heater regularly with a vacuum cleaner.
FILTRE
1/4 h
1/2 h1h
2h
26�07�80�0018
1
1 "Dust filter dirty" indicator
There is a dust filter on the air intake side of the rapid heater. If the
dust filter is dirty, the rapid heater is switched off and the "Dust
filter dirty" indicator lights up.
Clean the dust filter regularly:
Switch off the appliance by pressing the ON/OFF switch.
26�07�80�0015
Push the dust filter forwards and pull it up and out of the
appliance.
Clean the dust filter, e.g. with a vacuum cleaner.
Place the dust filter back in the appliance.
Wait approx. 10minutes before switching the appliance back
on.
6. Troubleshooting
Problem Cause Remedy
The heated air smells
unpleasant.
This can be caused by
dust during commis-
sioning.
The smell will dissipate within
a few minutes.
The appliance does
not heat up.
The MCB/fuse has re-
sponded/blown.
Replace the fuse/reset the
MCB.
The temperature sensor
is damaged (heating
indicator flashes 3 times
on start-up)
Call your qualified contractor.
The mains voltage to the
appliance is too high
(heating indicator flash-
es 5 times on start-up).
Switch the appliance off. Call
your qualified contractor.
The appliance heats
continuously.
The appliance is subject
to a continuous draught.
Remedy the cause of the
draught.
The temperature setting
was changed.
Set the required room tem-
perature at the temperature
selector.
There is a fault with the
power supply.
Disconnect the appliance
from the power supply for 10
minutes and then switch it
back on. If the problem occurs
regularly, arrange for your
power supply utility to check
the power supply.
The 24h automatic
function is not per-
formed.
There was a power
failure.
Set the 24h automatic func-
tion again.
The clocks have
changed to summer/
wintertime.
Set the 24h automatic func-
tion again.
The elements at the
very top and bottom
don't get as warm as
the rest of the appli-
ance.
The elements at the top
have not completely
filled.
The heating medium expands
when it gets warm. It takes
a little longer for these ele-
ments to heat up.
Dirty marks appear
on the wall around
the appliance.
Dirty marks are caused
by contaminated air
(candles, cigarette
smoke, poor ventilation,
etc.).
Remedy the cause of any air
contamination.
The boost function is
terminated prema-
turely
The dust filter is full or
the air intake or dis-
charge apertures are
blocked.
Clean the dust filter and the
air intake and discharge ap-
ertures.
The room temperature
is too high. For safety
reasons, the appliance
automatically switches
off the rapid heater pre-
maturely.
Switch the appliance off. Wait
at least 10 minutes before
switching the appliance back
on.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your request, provide the number from
the type plate (000000-0000-000000).
The type plate is located underneath the appliance on the right
hand side.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiebel Eltron BHE 100 Classic at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiebel Eltron BHE 100 Classic in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 9,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info