742471
12
Zoom out
Zoom in
Previous page
1/60
Next page
12 | BGC WWW.STIEBEL-ELTRON.COM
INSTALLATION
SAFETY
INSTALLATION
7. Safety
Only qualified contractors should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1 General safety instructions
We guarantee trouble-free operation and operational reliability
only if the original accessories and spare parts intended for the
appliance are used.
7.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
7.3 Water connection and safety assembly
Note
Carry out all water connection and installation work in
accordance with regulations.
The cylinder must be connected with water inlet and outlet pipes
made from metal. Other metal parts of the cylinder that can be
touched and that are in contact with water must be permanently
and reliably connected with the earth conductor.
The max. permissible pressure must not be exceeded (see chapter
“Specification/ Data table” and cylinder specification).
Install a type-tested safety valve in the cold water supply
line. For this bear in mind that, depending on the static pres-
sure, you may also need a pressure reducing valve.
Size the drain so that water can drain off unimpeded when
the safety valve is fully opened.
Fit the discharge pipe of the safety valve with a constant
downward slope and in a room free from the risk of frost.
The safety valve discharge aperture must remain open to the
atmosphere.
8. Equipment description
8.1 Standard delivery
Delivered with the appliance are:
- Extension, G 1½, 45 mm (BGC/45 | BGC 2/60)
- Wiring diagram label
8.2 Required accessories
Depending on the static pressure, safety assemblies and pressure
reducing valves are available. These type-tested safety assemblies
protect the appliance against unacceptable excess pressure.
9. Mounting
Note
Installation from below is not permissible for safety rea-
sons.
26�02�09�0001
Observe the permissible installation position in the cylinder
(see figure).
Always install the threaded immersion heater with heating
elements and a protective pipe arranged in parallel. Realign
the components where necessary.
During installation, ensure that the temperature selector is at
the top.
Screw on the appliance up to at least half of the thread. The
threaded immersion heater is sealed in by means of a seal
ring.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stiebel Eltron BGC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stiebel Eltron BGC in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 6,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info