Safety warnings
■ Disconnect the power supply before attempting any work on the unit!
■ During installation, the electrical wiring you are connecting must be dead. Therefore, switch "OFF" the
power first and use a voltage tester to check that the power supply is disconnected.
■ Installing these lights involves work on the mains voltage supply; this work must therefore be carried
out professionally in accordance with national wiring regulations and electrical operating conditions
(
D
- VDE 0100,
A
-ÖVE/ÖNORM E 8001-1,
-SEV 1000)
■ Do not install the unit on normally flammable surfaces.
■ Suitable for outdoor and indoor use.
■ LED floodlights are only intended for wall mounting and not for ceiling mounting.
■ The floodlight housing heats up while it is switched "ON". Only adjust the angle of the LED head once it
has cooled down.
■ Only use genuine replacement parts.
■ Do not dismantle the unit yourself. It must only be repaired by a specialist workshop.
■ Do not look directly at the LED light close up or for any length of time (> 5 min.). This could
lead to damage of the retina.
Installation advice
The mains supply lead is a 3-core cable.
L = phase conductor (mostly black, brown or grey)
N = neutral conductor (usually blue)
PE = protective-earth conductor (green/yellow)
Important: Getting the cable connections crossed will produce a short circuit in the unit or in your fuse
box. In this case, you must identify the individual cables and re-connect them. A mains switch for switching
the light "ON" and "OFF" can be installed in the mains lead.
Concealed wiring / surface wiring
Underneath the mounting plate you will find two lugs for surface wiring. Break off one of the two lugs. Use
the sealing plug to close off the cable opening in the mounting plate. Pierce the sealing plug and feed the
cable through. Once the cable has been pushed through, you can screw the mounting plate to the mount-
ing surface and complete the connection.
Troubleshooting (Cause ➩
Remedy
)
No voltage / Fuse faulty, not switched on, break in wiring ➩
New fuse, turn on mains power switch, check
wiring with voltage tester.
Short circuit ➩
Check connections.
Declaration of Conformity
This product complies with Low Voltage Directive 2006/95/EC / EMC Directive 2004/108/EC /
RoHS Directive 2011/65/EC / WEEE Directive 2012/19/EC
Functional Warranty
This STEINEL product has been manufactured with utmost care, tested for proper operation and safety and
then subjected to random sample inspection. STEINEL guarantees that it is in perfect condition and proper
working order. The warranty period is 5 years and on the date of sale to the consumer. We will remedy
defects caused by material flaws or manufacturing faults. The warranty will be met by repair or replace-
ment at our own discretion. The warranty does not cover damage to wear parts, nor does it cover damage
or defects caused by improper treatment, maintenance or the use on non-genuine parts. Further conse-
quential damage to other objects is excluded. Claims under the warranty will only be accepted if the unit is
sent fully assembled and well-packed with a brief description of the fault, a receipt or invoice (date of pur-
chase and dealer's stamp) to the appropriate Service Centre.
Service:
Our Customer Service Department will repair faults not covered by warranty or after the
warranty period. Please send the product well packed to your nearest Service Centre.
ENGLISH
31
2
110033116 01/2014_F
