619139
49
Zoom out
Zoom in
Previous page
1/52
Next page
49
TROUBLESHOOTING
STAR TRAC S SERIES TREADMILLS perform a self-test at the beginning of every workout. If a problem is detected, a
message displays before or after the workout, depending on the nature of the problem. Star Trac recommends that you refer
your questions about your STAR TRAC S SERIES TREADMILL operation and suspected malfunctions to Star Trac’s
Service Hotline at (800) 503-1221, or USA 1-714-669-1660.
START-UP SERVICE MESSAGES
The following messages are displayed at the beginning of a workout if the associated problem is detected during self-test.
NO STOP - This error generally occurs when the Stop Switch is not connected tightly to the circuit board of the Display
Control Panel. It may also happen if the circuitry associated with the switch develops a fault. When you see NO STOP:
Set the ON/OFF switch to OFF; wait 2 seconds.
Set the ON/OFF switch to ON. Notify Star Trac if additional assistance is needed.
KEY DOWN - This error generally occurs when a key is held pressed while the ON/OFF switch is moved to ON. It may also
happen if a key becomes stuck. When you see KEY DOWN:
Set the ON/OFF switch to OFF; wait 2 seconds.
Set the ON/OFF switch to ON. The treadmill should be operational again. Notify Star Trac if additional assistance is
needed.
SPEED CHANGE: This error generally occur when the running belt speed sensor is disconnected, faulty, or misaligned
relative to the revolutions-per-minute (RPM) sensor of the motor. It may also occur if the speed sensor cable is damaged, or if
the Motor Control Board (MCB) is misadjusted or faulty. When you see SPEED CHANGE:
Set the ON/OFF switch to OFF; wait 2 seconds.
Set the ON/OFF switch to ON. Notify Star Trac if additional assistance is needed.
ELEVATION STALL, ELEVATION RANGE OR ELEVATION LOST: These errors generally occur when the elevation
(incline) potentiometer is faulty or out of limits, or the elevation motor is disconnected or receiving low power. They may also
occur if the Motor Control Board (MCB) is faulty or the motor gears are stripped. They are usually accompanied by failure of
the treadmill to rise from an elevation other than maximum (or descend from an elevation other than minimum), with
attendant beep indication, when (or) is pressed. When you see ELEVATION STALL, ELEVATION RANGE OR
ELEVATION LOST:
Notify Star Trac for diagnosis and disposition.
49


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for StarTrac S-TRx Treadmill at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of StarTrac S-TRx Treadmill in the language / languages: English as an attachment in your email.

The manual is 2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info