619138

StarTrac E-ST 5090 Stepper Manual

13
Zoom out
Zoom in
Previous page
1/28
Next page
STAR TRAC E-ST STEPPER OWNER’S MANUAL 13
(b) It is now time to attach the display. NOTE: This step
assumes that you will be att
aching the LED display. Should you
be installing the embedded display or adding a PVS kit, please
refer to those applicable manuals. The following display con-
nections will need to be made: connect the main display cable
to the connector labeled J4 on the display PCB, connect the
heart rate grip cable to the heart rate board, and connect the
ground wire from the heart rate board to the quick disconnect
tab on the display weldment.
(c) With the display electrical connections made, you can now
attach the display. There are 2 tabs located on the bottom of the
display weldment, so in order to attach the display, you will first
need to guide the bottom of the display under the tabs and then
second you will need pivot the display forward around the tabs to
mate the display to the rear plastics. Once in place, you can attach
the screws.
(d) With the display in place, attach the 8 M4 x 0.7 screws provided.
6 screws go around the rear of the display and 2 go near the under-
side of the cupholders as shown.
5. Installing the Handrails
NOTE: It is recommended that this step be performed by at least 2 people.
(a) With the assistance of another person, tip the STAR TRAC E-ST STEP-
PER forward and hold in place while completing the following steps.
(b) Remove the 2 rear leg levelers.
(c) Slide the left handrail into the upper end of the left handlebar
weldment and line up the screw holes.
(d)
Loosely
attach 2
supplied button head screws to the lef
t handlebar
weldment junction
using a 5/32” (4mm) hex key or T-handle.
Board
1
ST
2
ND
J4
Ground Wire
Heart Rate
Board
Quick Disconnect
M4 x 0.7
Screws
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for StarTrac E-ST 5090 Stepper at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of StarTrac E-ST 5090 Stepper in the language / languages: English as an attachment in your email.

The manual is 1,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info