619112

StarTrac 7060 Series - Spinner Manual

10
Zoom out
Zoom in
Previous page
1/30
Next page
"# 

A
SSEMBLY
Following these steps in order will minimize the build time and ensure proper assembly.
1. Install the Back Leg
Lift up the rear of the bike frame and place
the rear leg assembly in position under the
frame, aligning the holes in the leg with the
holes in the frame.
Position the leg so the thicker end faces
toward the front of the bike
Using the 5mm hex wrench and a 13mm
combination wrench insert 2- M10X55mm
(rear-most holes) and 2-M10X65mm
(front-most holes) button head screws, nuts
and washers (under bolt head and nut), to
secure the rear leg assembly to the frame.
Tighten all hardware securely using a torque wrench to 85 lbs-in.
Step 1
2. Install the Handlebar
A.
Insert pop-pin into frame handlebar post. Tightly secure pop-pin into
place using multi-wrench.
B.
Position the handlebar post in its upright position
(numbers will be right side up).
Insert handlebar water bottle cage into the handlebar
post. Secure assembly with the:
• (2) M8x1.25, 16mm Flat Head Screw
• 5mm Hex Wrench
• Torque down to 60 lbs-in
• (1) M8x1.25, 16mm Socket Set Screw
• 4mm Hex Wrench
• Torque down to 60 lbs-in
C.
Slide the handlebar post into the frame making sure
the holes face the front of the bike.
Allow the post to go into the frame all the way in to
level 1 and align the pop pin so it snaps into the
hole then tighten the pop pin and test for steadiness.
Loosen the pop pin and raise the handlebar to its
highest position number 10 and tighten the pop pin
and test for steadiness.
Step 2A
Step 2B
Step 2C
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for StarTrac 7060 Series - Spinner at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of StarTrac 7060 Series - Spinner in the language / languages: English as an attachment in your email.

The manual is 3,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info