19
medical attention.
CAUTION: POTENTIAL EQUIPMENT MALFUNCTION OR FAILURE.
Do not operate with a damaged power supply cord or plug. Damage to the equipment may occur. Protect the
power supply cord from being walked on or pinched particularly at plugs, convenience receptacles and the point
where they exit from the product. Do not pull on cords or cables. When unplugging the cord from an electrical
outlet, grasp and pull the cord by the plug. If a cord or plug is damaged, have it replaced immediately.
CAUTION: POTENTIAL EQUIPMENT MALFUNCTION OR FAILURE. This equipment is supplied with a wall mount
power supply designed specically to operate on 100-240 V 50/ 60 Hz. If the cord is missing or damaged, replace
only with Stanley power supply specied for this equipment to avoid product damage.
CAUTION: POTENTIAL EQUIPMENT MALFUNCTION OR FAILURE.
To avoid potential damage caused by a power surge, utilize a surge protector.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
Dispose of used batteries according to the instructions.
IMPORTANT NOTICES
• This product is not user serviceable. There are no user serviceable parts inside the product. Servicing at •
• a STANLEY authorized service center is required to avoid damage to static sensitive internal components. •
• Unauthorized service will void the warranty.
• Clean only with a dry cloth.
• Although the noise level and duration of the siren are below OSHA limits, the loud noise from the sirens may
• startle the user.
PRODUCT LIMITATIONS
• Although this unit is designed as a personal property protection device, it does not guarantee protection
against burglary or other emergencies. Any alarm is subject to compromise or failure-to-warn for a variety of
reasons including, but not limited to, the following:
• An intruder may gain access through unprotected openings. An intruder with criminal intent, technical
• knowledge, or jamming devices, may bypass the alarm system.
• This product will not operate without power. The equipment has a rechargeable battery. If the battery has not
• been adequately charged, the product will not operate.
• Signals sent by radio may be blocked before they reach the server. Even if the signal path has been recently
• checked during a routine test, blockage can occur if the cellular signal is lost.
• An RFID signal is needed to arm, disarm, accept programming changes and transmit alarm signals. If reception
is not available, equipment is out of service.
• This product is a self-installed alarm. Carefully follow all instructions. Improper installation may compromise
the operation of this equipment.
• This alarm should be tested regularly to make sure all sensors and the RFID signal are working properly.
• Warning devices such as sirens may not alert people if they are out of range. Persons may not hear the
warning • if the alarm is mufed by a radio, operating equipment, appliances or passing trafc. Alarm warning
devices, however loud, may not warn hearing-impaired people.
• Despite advanced design and regular testing, this equipment, like other electrical devices, is subject to
• component failure.
• Installing this alarm may make one eligible for lower insurance rates, but an alarm is not a substitute
for insurance.
STANDARDS:
Area
EU
EU
EU
USA
Canada
USA
Type
Safety
Radio
Radio
Safety
Safety
Radio
Standard
EN 609050-1
EN 300328
EN 300330
UL 60950-1
CSA CS22.2 60950-1
FCC Part 15, Sub-Part B, C FCC ID GDOICS310000 FCC ID GDOICS311000
USA Energy California Code of Regulations Title 20, Section 1601 to 1608
