Manual Stanley STR-4 in 1 (page 16 of 240) (English, German, Danish, French, Italian, Swedish, Norwegian, Finnish)

720594

Zoom out

Zoom in

1/240

- Attach the cutting guard (15) with the 4 screws

on the retaining device on the shank (if not

already ﬁtted). In addition, the protective cover

must be ﬁtted with the blade at the cutting guard.

- Lock the shaft of the brush cutter at the required

position with a screwdriver or with the Allen key

(28).

- Loose with the spark plug wrench (29) the

locknut for the blade (14), by turning in a

clockwise direction (if already installed).

- Remove the hexagon nut (14), the clamping

ﬂange (13) and the retaining plate (16) for the

thicket of knives. Keep these parts sage.

- Leave the support ﬂange (17) on the shaft.

- Lock the shaft of the brush cutter at the required

position with a screwdriver or with the supplied

Hex Key (28).

- Rotate the thread spool (19) against the

clockwise on the shaft.

ATTENTION: Left hand thread

Connect the drive unit and assembly:

Put the ends of the modules to be connected

into one another. While doing so, make sure that

the lock pin (26) is snapped in place. Check by a

pulling apart by way of trial. Fold down the (26a)

cover and secure the modules by tightening the

locking screw (10).

Release of the drive unit and assembly:

Release the locking screw (10). The cover (26a)

jumps back. Hold the locking pin (26)found below

the cover pressed down and and at the same

time release the modules from one another by

carefully pull apart.

26a

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Stanley STR-4 in 1 in the language / languages: English, German, Danish, French, Italian, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 9,41 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Stanley STR-4 in 1 Manual

Product: