720276

Stanley ST-60V-GFA-E Manual

65
Zoom out
Zoom in
Previous page
1/71
Next page
© 2018 Pinnacle Climate Technologies, Inc.
The gas pressure regulator and hose
assembly supplied with the heater must
be used without alteration.
INSTALLATION
Minimum ventilation requirements: room volume should not
be less than 100 m³; minimum ventilation of 25 cm² per kW of
heat input subject to a minimum of 250 cm².
1. Inspect fuel cylinder and hose connection to appliance to
ensure it is in good condition.
2. Connect power cord to electrical supply outlet.
3. Connect Gas supply hose to heater. (Required hose and
regulator is to be 1.5 metres max and 1.0 metre min. in
length, and type EN16129). Connect other end (regulator) to a
fuel supply cylinder.
NOTE: Optimum efficiency is achieved when the heater uses
the appropriate full fuel supply cylinder.
4. Slowly open the fuel supply cylinder. Leak test all gas
connections with 50/50 soap and water solution prior to start-up
to ensure the heater is connected properly. Soap bubbles
indicate a gas leak. DO NOT use a match or flame to test for
gas leaks.
NOTE: Consult local regulations when planning to install an
air temperature control.
CHANGING FUEL SUPPLY CYLINDERS
1. When changing fuel supply cylinders, be sure this is done in a
flame-free atmosphere and non-smoking environment.
2. When you need to replace your empty cylinder, turn the gas off
first.
3. Make sure that the heater is extinguished completely.
4. Remove the regulator from the empty cylinder and change a
new full one.
LIGHTING AND OPERATING INSTRUCTIONS
1. Connect power cord to properly earthed socket. Connect heater
to a proper fuel supply cylinder.
2. Turn gas valve knob on the heater to the “O” (OFF) position.
3. Switch the electrical power switch to ON and check if fan is
operating correctly.
4. Wait five (5) minutes for any gas to clear. Smell for gas. If none
is evident, proceed to the next step.
5. Turn the knob at the fuel supply cylinder counterclockwise to
the OPEN position.
6. Push in the Gas Valve knob on the heater and hold it at least
five (5) seconds. Then turn the knob counterclockwise to the
(1/ ) position. This will light the burner. It may be necessary to
repeat this process a few times to light the heater.
7. Keep the valve knob depressed for at least 30 seconds after
the burner is lit. After 30 seconds release the control knob.
8. If burner does not stay lit, repeat Steps 5 and 6.
9. Check to see the appliance operating pressure is correct
according to gas chart (below).
SHUTDOWN INSTRUCTIONS
1. Turn gas valve control knob on the heater to the O (OFF)
position.
2. Turn the control knob at the fuel supply cylinder clockwise to
the CLOSED position.
3. Disconnect heater from power supply, and disconnect regulator
from the fuel supply cylinder.
SERVICING INSTRUCTIONS
These instructions are intended to be used only by competent
persons for carrying out all servicing operations authorized by the
manufacturer.
All special tools, materials or servicing aids necessary for the
correct servicing of the appliance shall be specified. Be sure to
check heater for soundness.
- Heater surface temperature must be cold before initiating
service, cleaning or storage.
- Maintenance and repair must be carried out by trained
personnel only at least 2 times per season.
- Before commencing service maintenance disconnect the unit
from the electrical power and the gas supply.
- Check the fuel supply hose condition and change if necessary.
- Check the ignition unit, safety thermostat, and thermocouple
condition and ensure that they are clean. If flame pattern
appears irregular, check nozzle. Wear eye protection when
performing these checks.
- Clean inside the heater unit and the fan blade with compressed
air. Heater is operating correctly when fan is running, flame is
present and soap test showed no leaks.
LONG TERM STORAGE
Always disconnect the heater from the fuel supply cylinder before
putting the heater into storage. If for any reason the heater is to
be stored indoors, the heater MUST be disconnected from the
fuel supply cylinder, and the cylinder stored outdoors in a well-
ventilated area, and out of the reach of children. If appliance is
unable to be left in a safe condition, disconnect the fuel cylinder
from appliance and store separately. The plastic valve plug
or valve cover supplied with the fuel supply cylinder must be
re-installed on the valve to protect the fitting from damage.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised
to ensure that they do not play with the appliance. If the power cord
is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
- NOTE: In some countries, there may be differences
in the requirements listed in this manual. In these
cases, contact your local dealer for possible
variations from requirements in this manual.
WARNING
Be careful to avoid torsional stresses in
the flexible tubing (regulator hose).
WARNING
Use the appropriate fuel supply cylinder
listed below.
ST-40-GFA-E : 9 Kg to 45 Kg fuel cylinder
ST-60V-GFA-E : 9 Kg to 45 Kg fuel cylinder
ST-100V-GFA-E : 9 Kg to 45 Kg fuel cylinder
ST-150V-GFA-E : 9 Kg to 45 Kg fuel cylinder
CAUTION
Disconnect heater from fuel supply
cylinder when not in use.
WARNING
4
I3B/P(50)
/ G30
Destination Country
Gas Type and Inlet Pressure
Gas
Category
Model No.
ST-60V-GFA-E
ST-100V-GFA-E
ST-150V-GFA-E
I3+(28-30/37)
/ G30
I3B/P(30) /
G30
I3P(30) / G31
G30 Butane at 28-30 mbar
G31 Propane at 37 mbar
GB, FR, IT, PT, IE
DE
NL, RO, TR
NL, NO, SE, DK, FI, RO, TR,
ES
G30 Butane at 30 mbar
G30 Butane at 50 mbar
I3B/P(37)
G30 Butane at 37 mbar
PL
I3B/P(37)
G31 Propane at 37 mbar
PL
G31 Propane at 30 mbar
I3P(37) / G31G31 Propane at 37 mbar
GB, FR, PT, IE
I3P(50) / G31G31 Propane at 50 mbar
NL, DE
ST-40-GFA-E
I3B/P(37)
G30 Butane at 37 mbar
PL
I3B/P(37)
G31 Propane at 37 mbar
PL
I3B/P(50)
/ G30
DEG30 Butane at 50 mbar
I3P(30) / G31
NL, RO, TR
G31 Propane at 30 mbar
I3P(37) / G31
G31 Propane at 37 mbar
GB, FR, PT, IE
I3P(50) / G31
G31 Propane at 50 mbar
NL, DE
I3B/P(50)
/ G30
Destination Country
Gas Type and Inlet Pressure
Gas
Category
Model No.
ST-60V-GFA-E
ST-100V-GFA-E
ST-150V-GFA-E
I3+(28-30/37)
/ G30
I3B/P(30) /
G30
I3P(30) / G31
G30 Butane at 28-30 mbar
G31 Propane at 37 mbar
GB, FR, IT, PT, IE
DE
NL, RO, TR
NL, NO, SE, DK, FI, RO, TR,
ES
G30 Butane at 30 mbar
G30 Butane at 50 mbar
I3B/P(37)
G30 Butane at 37 mbar
PL
I3B/P(37)
G31 Propane at 37 mbar
PL
G31 Propane at 30 mbar
I3P(37) / G31G31 Propane at 37 mbar
GB, FR, PT, IE
I3P(50) / G31G31 Propane at 50 mbar
NL, DE
ST-40-GFA-E
I3B/P(37)
G30 Butane at 37 mbar
PL
I3B/P(37)
G31 Propane at 37 mbar
PL
I3B/P(50)
/ G30
DEG30 Butane at 50 mbar
I3P(30) / G31
NL, RO, TR
G31 Propane at 30 mbar
I3P(37) / G31
G31 Propane at 37 mbar
GB, FR, PT, IE
I3P(50) / G31
G31 Propane at 50 mbar
NL, DE
THIS HEATER MUST BE INSTALLED BY
COMTETENT PERSONS IN ACCORDANCE
WITH SUCH REGULATIONS AS ARE IN FORCE.
WARNING
… 65 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stanley ST-60V-GFA-E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stanley ST-60V-GFA-E in the language / languages: English, German, Dutch, French, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 6,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info