720579

Stanley SPT-182-570 Manual

23
Zoom out
Zoom in
Previous page
1/233
Next page
23
4. Remove corrosion from battery terminals and
cable connections with a wire brush, then wash
with weak baking soda solution.
5. Apply a thin coat of grease or petroleum jelly to
terminals and cable ends to retard corrosion.
6. Attach and tighten the positive (red) battery cab
first, then the negative (black) battery cable.
7. Place the battery on the tray and Install the
cover.
Off-Season Storage
Refer to the Engine Manual for
information on storing your engine.
At the end of the season or if the snow
thrower will not be used for 30 days longer,
follow the storage instructions below.
1. Run the engine until the fuel lines and
carburetor are empty and it stops due to
lack of fuel.
2. Remove the safety ignition key and allow
the engine to cool.
3. Lubricate the machine as instructed.
4. Clean the exterior of the engine and the
snow thrower thoroughly.
5. Touch up all rusted or chipped paint
surfaces; sand affected areas before
painting, and use a rust preventative to
prevent the metal parts from rusting.
6. Tighten all loose screws, bolts, and
locknuts. Repair or replace any damaged
parts.
7. Cover the machine and store it in a clean,
dry place out of the reach of children.
Belt Replacement
Auger Belt
If the auger belt becomes worn, oil-soaked,
or otherwise damaged, proceed as follows to
replace the belt.
1. To prevent spillage, remove all fuel from
tank by running engine until it stops.
Remove the key to avoid unintended
starting and allow unit to cool completely.
2. Remove the two screws that hold the belt
cover in place and set the cover aside.
3. Roll the auger belt(s) off the engine pulley.
4. Carefully pivot the snow thrower up and
forward so that it rests on the auger housing.
G
B
… 23 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stanley SPT-182-570 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stanley SPT-182-570 in the language / languages: English, German, French, Italian, Finnish as an attachment in your email.

The manual is 23,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info