720569
7
Zoom out
Zoom in
Previous page
1/20
Next page
7
7
G
B
ASSEMBLY
Following the assembly directions below, you will
assemble the front tine tiller in a few minutes.
1.Place tilling tines on the tine shaft on both sides
of the gear box. Line up the holes in the tine frame
sleeves and tine shaft. Insert clevis pins through
the holes in tine frames and tine shaft. Insert cotter
pins through the holes in the clevis pins to secure
them.(Fig.2)
5
g.2
12
11
25/26
2. Install the resistance rod support with clevis pin,
and tight them with cotter pin. Insert the resistance
rod in the hole of resistance
rod support, then lock them with lock lever in
desired position.(Fig.3)
g.3
7
6
3. Mount the girder on the tiller with 2
M8*80 screws and flange nuts.(Fig.4)
g4
2
4. Install the handle on the girder with M 8*80
screw, washer and flange nut, then secure the top
of handle on the girder by installing the lock lever
in desired positions and insert washer and cotter
pins to keep them firmly (Fig.5).
g.5
17/26/27
16/17/18
5. Install the safety plate with 2x M 6*40 screws,
washers and flange nuts.(Fig.6)
g.6
8
20/21/22
6. Mount the Wheel assy on the tiller with screw
and flange nut, then hang extension spring (Fig.7).
16/17/18
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stanley SGT-51-820-H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stanley SGT-51-820-H in the language / languages: English as an attachment in your email.

The manual is 2,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info