720568
10
Zoom out
Zoom in
Previous page
1/20
Next page
10
10
LAYOUT
1. Handle
2. Gasoline engine
3. Blade cover
4.Blade disc
5. Wheel
6. Chain box
7. Blade
8. Resistance rod
9. Belt cover
10.Oil dispstick
11. Choke Lever
12.ON/OFF Switch
13.Recoiling Handle
14. Forward control rod
15. Reverse control rod
16. Adjust Nut
17. Spark cap
18. Spark Plug
OPERATION INSTRUCTION
1. Checking/Adding Oil (Figure 10)
Place engine in a horizontal position and clean the
oil fill area of any debris before adding or checking
the oil.
1) Remove the dipstick (G) and swipe with a clean
cloth.
2) Insert the dipstick into the filler neck without
screwing it in.
3) Pull the dipstick out and check the oil lever. The
oil lever should be in between the MIN.and MAX.
levels.
4) If low, add oil slowly into the engine oil fill
tube(G). Do not overfill. After adding oil, wait one
minute and then recheck the oil level.
5) Replace and tighten the dipstick.
g.10
Warning:
If the level is too low, it may cause serious damage
to the engine. When the engine is working,
please use clean and good quality 4-stroke engine
oil. Run with other engine oil or dirty oil may
shorten the lifetime of the engine severely.
2. Adding fuel (Figure 11)
1) Clean the fuel cap area of dirt and debris.
Remove the fuel cap.
2) Fill the fuel tank with gasoline. To allow for
expansion of the gasoline, do not fill above the
bottom of the fuel tank neck.
3) Reinstall the fuel cap.
CAUTION:
1) Turn engine off and let engine cool at least 2
minutes before removing the fuel cap.
2) Fill fuel tank outdoors or in well-ventilated area.
3) Do not overfill fuel tank. Fill tank to approximately
1.5 inches (38mm) below top of neck to allow for
fuel expansion.
4) Gasoline is extremely flammable and is
explosive. Do not smoke and allow flames or sparks
G
B
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stanley SGT-25-450-H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stanley SGT-25-450-H in the language / languages: English as an attachment in your email.

The manual is 2,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info