Manual Stanley FMC770 (page 3 of 35) (English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish)

720670

Zoom out

Zoom in

1/35

ENGLISH

(Original instructions)

ENGLISH

(Original instructions)

Additional safety instructions for batteries and

chargers

Batteries (not supplied)

u Never attempt to open for any reason.

u Do not expose the battery to water.

u Do not store in locations where the temperature may

exceed 40 °C.

Warning! batteries (battery pack or batteries installed) shall

not be exposed to excessive heat such as sunshine, re or the

like.

u Charge only at ambient temperatures between 10 °C and

40 °C.

u When disposing of batteries, follow the instructions given

in the section "Protecting the environment".

u Do not damage/deform the battery pack either by puncture

or impact, as this may create a risk of injury and re.

u Do not charge damaged batteries.

u Under extreme conditions, battery leakage may occur.

When you notice liquid on the batteries Carefully wipe the

liquid off using a cloth. Avoid skin contact.

u In case of skin or eye contact, follow the instructions

below.

Warning! The battery uid may cause personal injury or

damage to property. In case of skin contact, immediately rinse

with water. If redness, pain or irritation occurs seek medical

attention. In case of eye contact, rinse immediately with clean

water and seek medical attention.

Caution! Danger of explosion if battery is incorrectly replaced.

Replace only with the Stanley FatMax battery.

Adapter

u Your adapter has been designed for a specic voltage.

Always check that the mains voltage corresponds to the

voltage on the rating plate.

Warning! Never attempt to replace the adapter unit with a

regular mains plug.

u Have defective cords replaced immediately.

u Do not expose the adapter to water.

u Do not open the adapter.

u Do not probe the adapter.

u The adapter must be placed in a well ventilated area when

being used.

Electrical safety

Your adapter is double insulated; therefore no

earth wire is required. Always check that the

mains voltage corresponds to the voltage on the

rating plate. Never attempt to replace the adapter

unit with a regular mains plug.

Symbols on Adapter

Short circuit proof safety isolating transformer.

SMPS

The charger is intended for indoor use only.

Features

This appliance includes some or all of the following features.

1. Volume buttons

2. Power button

3. Mode button

4. Preset Toggle button

5. Set Preset button

6. Equalizer/Clock button

7. Bluetooth® button

8. Tune/Seek buttons

9. LCD display

10. Antenna

11. AC adapter port

12. 18v battery port

13. Auxillary port

14. Coin cell battery door

15. AC adapter

Use

remove plastic tab from the coin battery by pulling.

Operating the Radio

Your radio is equipped with memory capacity in order to store

the time and your selected preset channels. When the radio is

in the OFF position, this memory capacity is powered by one

coin cell battery that is included with the radio.

To Replace Coin Cell Battery

Warning! Do not ingest the battery, chemical Burn Hazard.

This product contains a coin/button cell battery. If the coin/

button cell battery is swallowed, it can cause severe internal

burns in just 2 hours and can lead to death.

Keep new and used batteries away from children.

If the battery compartment does not close securely, stop using

the product and keep it away from children.

If you think batteries might have been swallowed or placed

inside any part of the body, seek immediate medical attention.

Warning! Danger of explosion if battery is incorrectly

replaced. When replacing battery, replace it with the same or

equivalent type CR2032. Observe correct polarity (+ and –)

when replacing batteries. Do not store or carry batteries so

that metal objects can contact exposed battery terminals.

Warning! To reduce the risk of serious personal injury, turn

tool off and disconnect radio from power source before

installing/changing battery.

u Remove the screw from the coin cell battery door (14).

Remove the door from the radio.

u Install the coin cell battery so that the writing on the

battery faces out away from the radio.

u Replace the battery door and tighten screw.

Note: To reset the LCD display (9), clock and pre-sets,

remove the coin cell battery and reinstall. Follow this

procedure if the screen seems to lock in place.

Power/Volume Adjustment

To operate as a corded product

Insert the AC adapter (15) into the AC adapter port (11), then

plug the adapter into an appropriate AC power outlet or

generator.

To operate as a cordless product

Insert a fully charged 18v Stanley FatMax battery (not

included) into the battery port (12). Be sure battery is fully

seated.

Switching on and off

u To switch the radio on, press the power button (2).

u To switch the radio off, press the power button again (2).

u Press the top volume button (1) to increase the volume. To

decrease the volume, press the bottom volume button.

Note: If the battery is attached to the radio and the AC adapter

is plugged in at the same time, the radio will run off the

adapter and not drain the battery. Having both attached

simultaneously will not charge the battery.

Mode Function

To choose one of the mode functions (FM, AM, AUX, or

Bluetooth®) push the mode button (3) until the desired

function is displayed on the LCD screen. For example, if the

radio is on FM, push the mode button two times to change to

AUX.

Tune or Seek Function

Tune

Press the top tune/seek button (8) to quickly move the tuner

up the frequency band. To move the tuner down the frequency

band, press the bottom tune/seek button.

Seek

Press and hold the top tune/seek button (8), then release to

quickly scan up the frequency band to the next available

station. Press and continue to hold the button to seek directly

to a desired station. Press and hold the bottom tune/seek

button (8), the release to quickly seek down the frequency

band.

Program the Clock

The clock can be programmed with the power on or off.

u Press and hold the equalizer/clock button (6) until the hour

numbers of the digital time ashe on the LCD display (9),

then release the equalizer/clock button.

u Press the tune/scan buttons (8) up or down to set the

hour.

u When the correct hour is set, press the equalizer/clock

button once so the minute numbers ash.

u Press the tune/scan buttons up or down to set the

minutes.

u If you do not press a button within 5 seconds, the clock

programming feature will automatically return to the

previous setting.

u The Clock is set once the numbers stop ashing.

Program the Presets

6 FM and 6 AM radio stations may be independently set. After

programming the buttons, pressing the “1-6” preset toggle

button (4) will instantly change the frequency to the preset

station.

Program the Channels

u Turn power on (2).

u Press the mode button (3) until the desired mode is

selected (AM or FM).

u Tune the radio to the desired station (see Tune or Scan

Function).

u Press and hold the set/preset button (5). The “Mem” icon

will ash in the LCD display (9).

u Press the “1-6” preset toggle button (4) to scroll through

the 6 presets.

u Once it displays the desired preset number, press the set/

preset button.

u Repeat steps 3 through 6 to set the other memory buttons.

Equalizer Button

Set bass and treble

u Press the equalizer/clock button (6) once. The base

equalizer will appear on the LCD display (9).

u Press the up and down volume buttons (1) to set the

desired bass level.

u Press the equalizer/clock button a second time to get to

the treble equalizer.

u Press the up and down volume buttons to set the desired

treble level.

u Press the equalizer/clock button a third time to exit.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Stanley FMC770 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,3 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Stanley FMC770 Manual

Product: