603500
19
Zoom out
Zoom in
Previous page
1/38
Next page
Radar Installation Manual Page 21
Port Setup
When an optional Radar Antenna is connected, Port 1 of the NMEA In/Out Communication
Setup menu must be changed to RADAR as shown below for communications.
1. From the Chart page, press [MENU]. Move the ShuttlePoint knob to highlight
SETUP
MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight
ADVANCED SETUP and press [ENT].
3. Move the ShuttlePoint knob to highlight
IN/OUT CONNECTIONS and press [ENT].
4. Move the ShuttlePoint knob to highlight
PORT 1 INPUT and press [ENT].
5. Move the ShuttlePoint knob up/down to select
RADAR and press [ENT].
6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
2.8 CHART PLOTTERS SOFTWARE UPDATE
The Software CARD is used to update the software in the Chart Plotter to be compatible with
the Radar.
NOTE
Updating the software in the Chart Plotters with this Software CARD will erase all Marks and Routes
that you have stored. Please read carefully the following paragraphs.
2.8.0 Backing up Marks and Routes
If you have created Marks and Routes you will need to either make note and manually re-
enter them or purchase a optional User C-CARD.
Refer to the Chart Plotters’s Owner's Manual for backing up the points.
2.8.1 Installing Software
Once you have backed up your User Points:
1. Turn off the Chart Plotter and insert the Software CARD into any C-CARD slot on the
Chart Plotter.
2. Press and hold [PWR] until the Chart Plotter beeps, then release the key.
3. Wait until the Start screen is shown, then remove the CARD.
4. The software is now updated and the Chart Plotter is compatible with the Radar.
Figure 2.8.1 - Example of Start Up screen
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Standard Horizon MDS-10-4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Standard Horizon MDS-10-4 in the language / languages: English as an attachment in your email.

The manual is 1,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info