603500

Standard Horizon MDS-10-4 Manual

11
Zoom out
Zoom in
Previous page
1/38
Next page
Radar Installation Manual Page 13
12-24VDC
JUNCTION BOX
EXTERNAL SWITCH
Green
Blue
Black
White
Black
Orange
Red
Brown
Yellow
Figure 2.3 - Antenna Cable
2.4 CONNECTION PROCEDURE
NOTE
In the following procedure the small wires must be stripped and tinned, and then connected to the
proper connections in the Radar Junction Box, and to pins on the On/Off control switch. If you are
uncertain of your skill in completing these tasks, it is strongly advised to obtain the services of a
qualified technician. It is essential to the operation and reliability of your Radar that these
procedures are accomplished properly.
1. Arrange the free end of the Antenna cable so that the wires will reach their intended
points for connections.
2. The two large wires must reach a power panel; the five leads in the braided fabric jacket
must reach the Radar Junction Box and the two remaining leads must reach the desired
location for the On/Off control switch.
3. If the leads must go in different directions, first route the five leads in the fabric
braid to the Junction Box. Then extend the shorter leads using the same size or
larger size wire.
Please note that
the power supply level at the Junction Box should be at least 12V since due
the cable length the voltage at the Radar could drop below 10V.
The power supply cables should be of adequate diameter to feed the Radar, the Chart
Plotter, the Junction Box and eventually any other instrument connected. The larger the
diameter the better. A too small cable section could cause voltage drop over the cable with
consequential overheating and danger of fire.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Standard Horizon MDS-10-4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Standard Horizon MDS-10-4 in the language / languages: English as an attachment in your email.

The manual is 1,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info