603502
7
Zoom out
Zoom in
Previous page
1/18
Next page
FF525 Installation Manual Page 9
2.2 POWER CONNECTIONS
The installation of a switch is necessary to turn On or Off the FF525. STANDARD HORIZON
recommends connecting the FF525 and Chart Plotter to the same power switch (not
supplied) and fused source as shown in the following images below. Normally spare rocker
switch on a dash is used.
2.3 GPS CHART PLOTTER CONNECTIONS
The FF525 is connected to STANDARD HORIZON Chart Plotters via the Tee Cable. Refer
to the following images below.
2.3.1 Tee Cable
If the Tee Cable connector is too large to route through your boat, the FF525 can be opened
to remove the cable for easier routing. Also if the Tee Cable is not long enough cable can
also be added. For some installations, the Tee connector may protrude too far from the rear
of the Chart Plotter when the power cable is connected also. If this is the case the Tee
connector may be removed. After removal connect each wire of the FF525 and the Chart
Plotter via a terminal strip in a dry location or solder and heat shrink wire color to wire color
as shown in the table below:
FF525
Gray
White
Green
Gray
White
Green
Chart Plotter
Figure 2.3.1 - FF525 - Chart Plotter table
Figure 2.3.1a - Removing Power and Tee cables
WARNING
Before following the steps below, disconnect 12VDC from the FF525.
1. Open the FF525 box by unscrewing the four screws.
2. Once the screws are removed, pull out the panel and the Printed Circuit Board (PCB).
3. Losen and remove the Green, White and Gray wires from the terminal strip.
4. Then lossen the cap and pull the wires from the inside of the FF525.
5. Route the Tee Cable as need through the vessel and or add additional cable if needed.
6. If the cap was removed, insert it onto the Tee Cable, then insert the cable into the FF525.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Standard Horizon FF-525 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Standard Horizon FF-525 in the language / languages: English as an attachment in your email.

The manual is 0,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Standard Horizon FF-525

Standard Horizon FF-525 User Manual - English - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info