603481

Standard Horizon CP390i - GPS Chart Plotter Manual

155
Zoom out
Zoom in
Previous page
1/168
Next page
Page 156 CP390i and CPF390i
precision of the positioning system (GPS). The smaller the HDOP/VDOP value, the more
accurately the position fix is provided.
HEIGHT – The current tide height referred to the vertical cursor.
HIGH WATER – The maximum level of the tide height in 24 hours.
LOW WATER – The minimum level of the tide height in 24 hours.
PINGO – It is a mound of earth-covered ice found in the Arctic and subarctic that can reach
up to 70 metres (230FT) in Height and up to 600 metres (2.000 FT) in diameter.
Position Request – Marine DSC VHF Function of transmitting a GPS position to another
Marine DSC VHF. When GPS Chart Plotter is connected to STANDARD HORIZON GPS
the position of another vessel is shown on the Chart page.
SPEED – Shows the Speed Thru the Water when a Digital Speed Log is connected.
SOG (Speed Over Ground) – The speed you vessel is travelling at.
STEER – Heading to steer to destination Waypoint.
TIME – Shows the current time received by the GPS.
TRIP LOG – Shows the distance the vessel has travelled since the trip log was reset.
TRU Wind DIR (True Wind Direction) – Shows the True Wind Direction when an external
wind instrument with NMEA is connected.
TRU Wind SPD (True Wind Speed) – Shows the True Wind Speed when an external wind
instrument with NMEA is connected.
TTG (Time To Go) – Shows time to go to reach a Destination point.
UNITS
Nm Nautical Mile (1 NM = 1.15 Sm or 1.85Km)
Sm Statue Mile (1Sm = 0.87Nm or 1.61Km)
Km Kilometer (1 Kilometer = 0062 Sm or 0.54Nm)
FT Feet (1 Foot = 0.167 Fathoms or 0.305 Meters)
FA Fathom (1 Fathom = 6 Feet or 1.83 Meters)
Mt Meter (1 Meter = 3.28 Feet or 0.55 Fathoms)
Kts Knot (1 Knot = 1.15 MPH or 1.85 KPH)
MPH Miles Per Hour (1 MPH = 0.87 Knots or 1.61 KPH)
Kmh Kilometer Per Hour (1 KPH = 0.54 Knots or 0.62 MPH)
VMG – It is the destination closing Velocity. The VMG is calculated using the current speed
of the vessel (SOG) and the difference between the current vessel course and the bearing
to the Destination.
WAAS 2D/3D – The GPS is receiving a 2D or 3D position and the correction from the WAAS
Satellite. WAAS consists of approximately 25 ground reference stations positioned across
the United States that monitor GPS satellite data. Two master stations, located on either
coast, collect data from the reference stations and create a GPS correction message. This
correction accounts for GPS satellite orbit and clock drift plus signal delays caused by the
atmosphere and ionosphere. The corrected differential message is then broadcast through
one of two geostationary satellites, or satellites with a fixed position over the equator. The
information is compatible with the basic GPS signal structure, which means any WAAS-
enabled GPS receiver can read the signal.
… 155 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Standard Horizon CP390i - GPS Chart Plotter at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Standard Horizon CP390i - GPS Chart Plotter in the language / languages: English as an attachment in your email.

The manual is 4,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info