603493
13
Zoom out
Zoom in
Previous page
1/42
Next page
Radar Operation Manual Page 15
12. Move the ShuttlePoint knob down to highlight MBS and adjust to 000 by moving the
ShuttlePoint knob to the right.
13. Move the ShuttlePoint knob down to highlight
TX TRIGGER DELAY and adjust moving
the ShuttlePoint knob to the right to a point that the center looks as a solid circle as
shown in the diagram below.
14. To save the TX Trigger Delay setting, move the ShuttlePoint knob down to
Done and
press [ENT].
098
Figure 3.1.0c - Adjusting Trigger Delay
MBS (Main Bang Suppression) Adjustment
(ONLY FOR MDS-9 DOME & MDS-10-4/MDS-10-5 OPEN ARRAY ANTENNAS)
The MBS is used to remove the echo closest to the vessel as shown in the right image in
figure 3.1.0c. If Main Bang appears at the screen center (it looks like a as a circular dot)
suppress it as follows:
1. Transmit on a long range about ten minutes.
2. Press [MENU]. Move the ShuttlePoint knob to highlight
TUNING and press [ENT].
3. Move the ShuttlePoint knob to highlight
TX TRIGGER DELAY and press [ENT].
4. Move the ShuttlePoint knob to highlight
GAIN and press [ENT]. Adjust the Gain in such
a way that the circular dot is clearly displayed.
5. Move the ShuttlePoint knob to highlight
MBS and press [ENT]. Increase the MBS value
until the circular dot is completely erased from the screen. Do not increase the MBS
more than the value required to completely erase the main bang it otherwise you run the
risk to suppress also target echoes.
3.1.1 Automatic Tune (NOT NECESSARY AT FIRST INSTALLATION)
The Tune control is used to tune the receiver in the Radar antenna for maximum target
returns on the display.
The Radar comes from the factory already tuned so this operation
is not necessary at first installation. In general Radar tuning may be necessary if the Radar
antenna was serviced.
Automatic Tune
In Automatic Tune mode, the Radar tunes itself automatically on all range scales. It is
recommended to execute the Tune function in Automatic mode. This generally ensures that
the Radar receiver is always tuned to receive the maximum signal.
After the Radar Antenna is installed (or has been on the vessel for a year or longer) perform
the Automatic Tune procedure, which adjusts the receiver Gain to show targets on all
ranges.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Standard Horizon CP300i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Standard Horizon CP300i in the language / languages: English as an attachment in your email.

The manual is 2,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info