644328
3
Zoom out
Zoom in
Previous page
1/8
Next page
2
3
1. L/MONO - R These are two unbalanced 2-pole phone
jacks for stereo line input. The input level range is -10dB. If
the source signal is mono please use the left channel.
2. -10dB Press this switch to attenuate the line input signal
-10dB to t the high level signal source.
3. HI Use this control to raise or lower the high frequencies.
Max adjustment range: 15KHz ±15dB.
4. MID This control determines the level of mid frequencies
in the output signal.
5. LOW Use this control to raise or lower the low
frequencies. Max adjustment range: 80Hz ±15dB.
6. AUX Use this knob to control the signal level sent from
each channel to the AUX bus. It is set before the channel
fader, so it is not dependent on the fader position.
7. BAL The BAL control for the stereo channels determines
the relative volume of the left and right input signals.
8. LEVEL This rotary fader controls the output level feed to
the main bus from the input channel.
13. +48V Phantom Power Switch and Indicator
This switch is used for turning on or off +48V phantom
power. +48V voltage will be present on the socket of each
microphone input channel when this switch is pressed down.
Important: set all channel faders to minimum before
turning this switch on or off. Do not plug or unplug a
microphone after this switch has been turned on. Do not
turn on the switch when a dynamic microphone is in use.
MONO CHANNEL SECTION
STEREO CHANNEL SECTION
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stagg S MIX 4M2S UD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stagg S MIX 4M2S UD in the language / languages: English as an attachment in your email.

The manual is 2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info