• The dehumidifier is designed for private use indoors and is not intended
for commercial use.
• Do not use the dehumidifier if it is faulty or could show signs of damage,
or if it is not functioning correctly. Disconnect the plug from the power
socket.
• The appliance shall be installed in accordance with national wiring regu-
lations.
Seting up / operation
1. Place Albert little on a flat surface in the desired area. Plug the power
cable (13) into an electric socket.
2. Press the on/off switch (3) to turn on the dehumidifier.
3. You can select the speed of the fan in the dehumidifier by pushing
the speed level selector (5). There are 2 speed levels. If the speed is
higher, the dehumidifying performance also increases.
4. With the hygrostat (4) the desired humidity level can be set (Con =
continuos). A humidity level not higher than 60 % is suggested in
general. If the dehumidifier reached the selected humidity it will turn
off and after that check the humidity level in constant intervals by
turning on the fan for a short time.
5. The swing mode (6) allows to optimally distribute the dry air in the
room. This mode is also suitable for example to dry clothes fast and
efficient.
6. If you find the control panel and LED too bright (in a bedroom for exam-
ple), you may reduce the light intensity by pressing the night mode (7).
7. Once the water tank is full, the blinking symbol will appear on the
control panel and the dehumidifier turns off automatically. Please
empty the tank. Once you put back the tank, the unit will automati-
cally restart.
8. Defrost function: If the temperature in the room is below 5 °C, the
dehumidifier automatically runs in defrost mode. This mode is shown
on the control panel and frost build up in the unit will be avoided during
dehumidification. This function will be activated every 25 minutes for
a duration of 7 minutes.
9. If desired, it is possible to connect a drainage hose to the unit for per-
manent water drainage. In this case connect the hose (2 m) (14) to the
unit through the hole in the back of the dehumidifier and place the
end of the drainage in a water outlet. Please make sure the end of the
hose is lower than the spout, otherwise the water will not drain and
flooding may occur.
10. For easy side movement of the unit there are hidden wheels (15) at-
tached. Empty the tank first before moving the dehumidifier.
Cleaning
Before servicing the appliance and after each occasion of use, switch off the
appliance and unplug the mains cable from the socket.
• Attention: Never immerse the appliance in water (danger of short-circuit).
• To clean the appliance, only wipe it down with a damp cloth and then dry
it carefully.
• In case the filter (10) at the air inlet (9) is dirty or dusty, take the filter out
and remove the dirt/dust with a vacuum cleaner.
