for 8 seconds, and the function will be counting up from zero directly if the training is going.
Press “MODE” button for confirmation and skip to next set-up.
4. In SCAN mode shown as “Drawing C”. RPM/SPEED/TM/DIST/CAL/PULSE will skip to
display in every 6 seconds. The order is as follows.
Drawing C
5. You can also press “MODE” button to select single function display except RPM & SPEED
function. The RPM & SPEED function will switch display.
6. RECOVERY
(1) When the user presses “RECOVERY” button, the RECOVERY function is active. At this
time only PULSE and TIME is working, other functions will not be displayed, and the Sensor
Input is not available. TIME starts to count down from ”0：60”, Pulse signal will be blinking
according user’s heart rate BPM. When Time counts down to “0”, it will show F1~F6 (F1 is
the best, F6 is the worst).
(2) LCD display as follows: (RECOVERY start condition & end condition).
(3) If the countdown action to 0:00 is not completed and there is no pulse signal, the
countdown action has to be done and shown F6.
(4) If you press the RECOVERY button prior to count down to 0:00, it will be end and return to
the main menu.
