Manual Spirit XT475 2007 (page 10 of 33) (English)

584057

Zoom out

Zoom in

1/33

XT375 / XT475 / XT675

!!ATTENTION: IMPORTANT UNPACKING INSTRUCTIONS. PLEASE

READ BEFORE UNPACKING YOUR FOLDING TREADMILL!!

Serious injury could occur if this folding treadmill is not unpacked properly.

There is a Velcro strap installed around the treadmill base that prevents the treadmill from

unfolding accidentally during shipping. If this strap is not removed properly the treadmill could

spring open unexpectedly and cause injury if someone is standing near the treadmill when

the strap is removed.

To ensure your personal safety during removal of the shipping strap please make sure the

treadmill is positioned flat on the ground, in the orientation it would be in if you were using the

treadmill. Do not turn the treadmill up on it’s side while removing the shipping strap. This could

cause the treadmill’s folding mechanism to spring open. If the end of the Velcro strap (that you

need to grab to remove it) happens to be under the treadmill deck, reach under the deck to grab

it, but do not tilt the treadmill up to gain access to the strap end.

Assembly (XT375 /XT475)

Unpack the treadmill and locate the hardware pack. The hardware pack is separated into: one

section containing tools and four sections labeled steps 1-4 which contain the hardware needed

for assembly of each step. The assembly steps below are numbered one through four and

correspond to the hardware in the numbered sections of the hardware pack. Remove only the

hardware for the step you are currently assembling to avoid confusion and mix-ups.

STEP 1

1. Take the Left and Right upright tubes and slip the upright covers onto the tubes (observe

the cover orientation is correct). Connect the Middle Console Cable that exits from the

bottom of the right upright tube with the lower Console Cable. Install the Left and Right (L

& R) Uprights into the Left and Right Receiving Tubes. Be careful not to pinch the wire

when installing the upright.

2. Then install and hand tighten the eight 5/16”x 5/8” Button Head Socket Bolts in the

remaining holes on the sides and front of the L & R tubes.

3. Install the six M5 Speed Nut on the Frame Base left and right side.

4. Install the Left & Right Frame Base Caps into the Frame Base with the six 5x16m/m

Tapping Screws by using the Combination M5 Allen Wrench & Phillips Head Screw Driver.

Do not tighten these bolts until assembly is complete. This makes aligning the

holes for mounting the console easier.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Spirit XT475 2007 in the language / languages: English as an attachment in your email.

The manual is 0,87 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Spirit XT475 2007 Manual

Product: