583954
5
Zoom out
Zoom in
Previous page
1/19
Next page
4
Treadmill
XT385
5
Treadmill
XT385
Please read before unpacking your folding treadmill. Serious injury could occur if this folding treadmill
is not unpacked properly.
There is a Velcro strap installed around the treadmill base that prevents the treadmill from unfolding accidentally
during shipping. If this strap is not removed properly the treadmill could spring open unexpectedly and cause injury if
someone is standing near the treadmill when the strap is removed.
To ensure your personal safety during removal of the shipping strap please make sure the treadmill is positioned at
on the ground, in the orientation it would be in if you were using the treadmill. Do not turn the treadmill up on its
side while removing the shipping strap. This could cause the treadmill’s folding mechanism to spring open. If the end
of the Velcro strap (that you need to grab to remove it) happens to be under the treadmill deck, reach under the
deck to grab it, but do not tilt the treadmill up to gain access to the strap end.
Cut the banding straps with a short box cutter (razor knife); separate the carton from the one underneath it by
prying up on the staples (if applicable). Pull the carton over the treadmill parts and locate the hardware pack. The
hardware pack is separated into ve sections; one section containing tools and four sections labeled steps 1-4 which
contain the hardware needed for assembly of each step. The assembly steps below are numbered one through four
and correspond to the hardware in the numbered sections of the hardware pack. Remove only the hardware for the
step you are currently assembling to avoid confusion and mix ups.
Then remove the treadmill from the carton and lay it on a level surface.
Important Operation Instructions
Pre-Assembly
XT385
Assembly Instructions
Assembly Tools
NEVER operate this treadmill without reading and completely understanding the results of
any operational change you request from the computer.
Understand that changes in speed and incline do not occur immediately. Set your desired
work level on the computer console and release the adjustment key. The computer will obey
the command gradually.
NEVER use your treadmill during an electrical storm. Surges may occur in your household
power supply that could damage treadmill components. Unplug the treadmill during an
electrical storm as a precaution.
Use caution while participating in other activities while walking on your treadmill; such as
watching television, reading, etc. These distractions may cause you to lose balance which may
result in serious injury.
Do not use excessive pressure on console control keys. They are precision set to function
properly with little nger pressure.
A safety tether cord is provided with this unit. It is a simple magnetic design that should be
used at all times. It is for your safety should you fall or move too far back on the tread-belt.
Pulling this safety tether cord will stop tread-belt
movement. To Use:
1. Place the magnet into position on the round metal portion of the console control head.
Your treadmill will not start and operate without this. Removing the magnet also secures
the treadmill from unauthorized use.
2. Fasten the plastic clip onto your clothing securely to assure good holding power. Note: The
magnet has strong enough power to minimize accidental, unexpected stopping. The clip
should be attached securely to make certain it does not come off. Be familiar with its
function and limitations. The treadmill will stop, depending on speed, with a one to two
step coast anytime the magnet is pulled off the console. Use the Stop / Pause switch in
normal operation.
Safety Tether Cord
#131. Combination M5 Allen Wrench/
Phillips Head Screw Driver
#132. M6 Allen
Wrench
#75. Safety Key
#30. Deck/Belt
Lubricant
#148. Phillips Head Screw Driver
To assist you in assembling your new Spirit Fitness treadmill, we have posted an assembly video at the following link:
http://www.spirittness.com/customerservice/video/treadmillvideos.html
Assembly Video
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Spirit XT385 2011-2012 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Spirit XT385 2011-2012 in the language / languages: English as an attachment in your email.

The manual is 6,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info