584056
16
Zoom out
Zoom in
Previous page
1/33
Next page
XT375 / XT475 / XT675
15
!!ATTENTION: IMPORTANT UNPACKING INSTRUCTIONS. PLEASE
READ BEFORE UNPACKING YOUR FOLDING TREADMILL!!
Serious injury could occur if this folding treadmill is not unpacked properly.
There is a Velcro strap installed around the treadmill base that prevents the treadmill from
unfolding accidentally during shipping. If this strap is not removed properly the treadmill could
spring open unexpectedly and cause injury if someone is standing near the treadmill when
the strap is removed.
To ensure your personal safety during removal of the shipping strap please make sure the
treadmill is positioned flat on the ground, in the orientation it would be in if you were using the
treadmill. Do not turn the treadmill up on it’s side while removing the shipping strap. This could
cause the treadmill’s folding mechanism to spring open. If the end of the Velcro strap (that you
need to grab to remove it) happens to be under the treadmill deck, reach under the deck to grab
it, but do not tilt the treadmill up to gain access to the strap end.
Assembly (XT675)
Unpack the XT800 and locate the hardware pack. The hardware pack is separated into: one
section containing tools and four sections labeled steps 1- 4 which contain the hardware needed
for assembly of each step. The assembly steps below are numbered one through four and
correspond to the hardware in the numbered sections of the hardware pack. Remove only the
hardware for the step you are currently assembling to avoid confusion and mix-ups.
STEP 1
1 Take the Right upright tube and connect the Middle Console Cable that exits from the
bottom of the tube, with the lower Console Cable. Install the Left and Right (L & R)
Uprights into the Left and Right Receiving Tubes. Be careful not to pinch the wire
when installing the upright.
2. Install and hand tighten the two 3/8” x 2” Button Head Socket bolts, two 3/8” split washers
and two10 m/m Beveled Washers into the top holes on the front sides of the L & R tubes.
Then install and hand tighten the 6pcs of 5/16”x 15mm Button Head Socket Screw in the
remaining holes on the sides and front of the L & R tubes. Do not tighten these screws
until assembly is complete. This makes aligning the holes for mounting the
console easier.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Spirit XT375 2007 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Spirit XT375 2007 in the language / languages: English as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info