518569
9
Zoom out
Zoom in
Previous page
1/18
Next page
5
e
Glide Trainer
XG200
1. The computer cable is pre-installed to the console mast and main frame so be careful not to pull too hard on
the console mast during assembly to avoid damaging them.
2. Connect cable (100) to (101).
3. Place the console mast onto the mating plate of the main frame; Be careful not to pinch the speed sensor wire
between the console mast and the main frame plates during assembly.
4. Secure the console mast in place with the four stainless steel bolts (42) and split washers (50). Make sure the
bolts are securely tightened using the 8mm Allen wrench (108).
5. Attach the hand brake lever (90) to the handlebars as follows:
HARDWARE
STEP 1: Console Mast
#42. M10 x 20mm
Stainless Steel Bolt
(4 pcs)
#50. M10
Split Washer
(4 pcs)
Remove the screw that is threaded into the nut on the backside of the hand brake with the Phillips head
screw driver (107)
Place the hand brake bracket around the front of the right handlebar vertical tube, then insert the bolt
through the back of the bracket and thread back into the nut. Tighten with the Phillips head screw driver
(107)
Loosen the two cable retainer brackets on the back of the console mast with the Phillips head screw driver
(107) just enough to allow the cable to nest behind them. Retighten the screws after placing the cable
behind them.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Spirit XG-200 Home E-glide at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Spirit XG-200 Home E-glide in the language / languages: English as an attachment in your email.

The manual is 3,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Spirit XG-200 Home E-glide

Spirit XG-200 Home E-glide User Manual - Dutch - 3 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info