584033
27
Zoom out
Zoom in
Previous page
1/28
Next page
ET2 / ET4
26
Before contacting your dealer for aid, please review the following information. It may save you
both time and expense. This list includes common problems that may not be covered under
the treadmills warranty.
PROBLEM SOLUTION/CAUSE
Display does not light Tether cord not in position.
Circuit breaker on front grill tripped. Push circuit breaker in
until it locks.
Plug is disconnected. Make sure plug is firmly pushed into the
AC household wall outlet.
Household circuit breaker may be tripped.
Treadmill defect. Contact your Spirit dealer.
Treadmill belt does not stay centered
Treadmill belt hesitates when walked/run on A user may be walking while favoring or putting more weight
on either the left or right foot. If this walking pattern is natural,
track the belt slightly off-center to the side opposite from the
belt movement. See General Maintenance section on
Treadmill belt Tension. Adjust as necessary.
Motor is not responsive / Display is lit Make certain clock is running. If it is then service may be
Needed.
Treadmill will only achieve approximately
7 mph but shows higher speed on display This indicates motor should be receiving power to
operate. Low AC voltage to treadmill. Do not use an
extension cord. If an extension cord is required it should be
as short as possible and heavy duty 16 gauge minimum. Low
household voltage. Contact an electrician or your Spirit dealer.
A minimum of 110 volt AC current is required.
Treadmill belt stops quickly/suddenly when High belt/deck friction. See General Maintenance
tether cord is pulled section on lubrication.
Treadmill trips on board 15 amp circuit High belt/deck friction. See Belt/deck lubrication procedure
Computer shuts off when console is
touched (on a cold day)while walking/running Treadmill is not grounded. Static electricity is crashing the
computer. Refer to Grounding Instructions on page 4.
ERROR MESSAGES:
1. LS: The treadmill hasnt received a speed signal for 8 seconds.
2. E1: Incline position error.
3. E2: Console memory malfunction or CPU accessing problem.
Service Checklist - Diagnosis Guide
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Spirit ET2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Spirit ET2 in the language / languages: English as an attachment in your email.

The manual is 0,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info