733464
16
Zoom out
Zoom in
Previous page
1/28
Next page
13
5.2. SHIFT/BRAKE
1
INSERT 4-5mm OD
CENTER PUNCH
START
FINISH
FINISH
Before starting this process, the link and shock should be assembled to the frame (see section 4.4).
Route the rear brake internal routing tube through the chainstay, starting at the non-drive side main pivot hole.
When the tube gets close to the non-drive side exit port, use a 4-5mm OD center-punch to help guide the tube
out of the hole.
Guide the tube out the exit port until about 50mm of tube is exposed.
Mark the brake tube at the end that will exit the head tube (see fig.3).
Repeat the process for the shift tube on the drive side (the shift tube goes above the brake tube when passing
through the main pivot area).
Be careful not to kink the guide tubes when routing. Installing brake or shift housing through guide
tubes before routing (with a few inches extending out of the tubes) will prevent kinking and can be
used to guide the tubes through the frame. Curve the housings downward as they enter the front
triangle to help the routing process.
If the chainstays need to be removed and re-installed after the guide tubes are cut, it is
recommended to ONLY remove the tubes from the head tube while keeping them attached in the
chainstays. Remove the set screw in the head tube and gently push the tubes from the port using a
sharp screwdriver or narrow chisel. Re-install in the same manner.
2
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Specialized Stumpjumper at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Specialized Stumpjumper in the language / languages: English as an attachment in your email.

The manual is 5,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info