810288
8
Zoom out
Zoom in
Previous page
1/27
Next page
GB 8
During this first burn, unpleasant odours may be produced. This is because
the anti-corrosion coating inside the combustion chamber is burning into
the steel surface. This is not a health hazard, but it does smell unpleasant.
Ensure sufficient ventilation in the installation space.
CAUTION! During a burning operation, the surfaces of the window
panes and cladding components can become very hot: Risk of burn
injuries!
3.2 HEATING AND FIRING
A good combustion requires correctly prepared fuel, the correct combustion
temperature for each burn-up phase and a suitable supply of oxygen to ena-
ble the system to function in an environmentally friendly and energy-efficient
manner.
3.2.1 IGNITION (DOWN BURN)
Principle: This firing method is a simple and effective way to reduce the
emissions from fire areas. The stack of wood burns downwards, from top to
bottom. With this firing method, all gases pass through the hot combustion
zone (flames) above the stack, enabling complete combustion to take place.
The wood further down is heated up gradually, gas flows outwards and burns
in the hot combustion zone. The result is combustion that runs much more
uniformly than when setting a fire from the bottom of the stack of wood.
Caution: The important thing about this process is that it prevents
rapid burn-up in a downwards direction. The lighting of firewood in
fire areas, and the correct stacking of that firewood together with
initial observation of the fire in respect of finding the most suitable
setting for combustion air all requires a certain level of experience.
Procedure:
1. Open the combustion chamber door (swivel or slide upwards).
Depending on the length of firewood and the dimensions of the combustion
chamber, narrow fireplace inserts are filled with firewood that points towards
the front. Wide fireplace inserts are filled with the longitudinal side facing for-
wards, i.e. with the firewood arranged sideways. Note the wood feed quantities
defined in chapter „2.1.3 Quantities of wood”.
4. For the highest layer, sufficiently thin kindling is laid. Softwood is recom-
mended here (e.g. fir)
2. Start by stacking wood crosswise on the ash
left on the grate. Use the thicker firewood at
the bottom, with progressively thinner wood
towards the top of the stack.
3. Open the combustion air inlet fully. Using the
‘cold hand, turn the actuating lever into initial
combustion position (+).
+
-
- Vertically-oriented sliding equipment - do not
close door completely, but instead leave a gap
of 3 - 5 cm.
Premium insert
Standard insert
- With Premium inserts push the door upwards for
opening using the foldaway handle.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Spartherm Swing Corner at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Spartherm Swing Corner in the language / languages: English as an attachment in your email.

The manual is 1.24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Spartherm Swing Corner

Spartherm Swing Corner User Manual - German - 27 pages

Spartherm Swing Corner User Manual - Dutch - 27 pages

Spartherm Swing Corner User Manual - French - 27 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info