744242
26
Zoom out
Zoom in
Previous page
1/53
Next page
GB 26
activate the operating handle and the “cold hand”. The glove is
not fire-proof!
The stove may only be operated with the fire door closed. The door should
be kept in a cold state is always closed. Only open the door for firing,
refueling and cleaning!
The fireplace must never be modified! In particular, never insert any instal-
lation components into the combustion chamber, combustion air passages
or flue gas flue that have not expressly approved by Spartherm. Your
fireplace warranty and operating permit will be rendered invalid by any
fireplace modification that has not been approved.
You may find that extractor hoods, ventilation equipment, etc. installed in
the same room (or linked space) as your fireplace or stove have a negative
effect on the operation of the Kaminofen (such as the release of smoke
into the room). These devices should not be used at the same time as your
fireplace or stove, without first ensuring that the necessary room heating
system precautions have been taken. („2.3.2.3 Room-air-independent“)
In particular when operating several fireplaces in a single room or linked
space, ensure that sufficient air is available for complete combustion!
This is a temporary fire area thus, longer continuous burning is not
achieved by piling up the fire repeatedly. Continuous burning without piling
up the fire in-between cannot be achieved even through withdrawal of
the combustion air and is also not permitted. A longer heating period is
achieved by repeatedly restoking the fire with suitable amounts of fuels.
Only non-combustible materials must be placed in the lower compartment
of the cladding!
3.2 S-THERMATIK MINI
Supply voltage: 230 V / 24V (via
wall plug transformer)
Power consumption during operation approx. 10 VA
Power consumption in "Stand-by": ca. 6 VA
Safety class: III (safety extra-low voltage)
Degree of protection: IP 50
The S-Thermatik Mini combustion control is pre-set to your stove ex-factory.
Changes to the control parameters must only be carried out by an installer
/ stove fitter or the customer services. Please also follow the accompanying
service instructions!
3.2.1 COMMISSIONING THE S-THERMATIK MINI
In order to guarantee an optimum and trouble-free operation of the fire area,
the door contact switch must be kept free from dirt and grime.
Before opening the fire door, make sure that the selector switch points to
"automatic" when the combustion air control is switched on. In automatic
operation, the control is activated from the stand-by by opening the fire
door. Now the actuator motor runs the dosing facility for the combustion
air to the position "open". The logs are placed and ignited (see also "4.
Combustion"), the firebox door closed. Then, the combustion air is set and
controlled automatically via the actuator motor on the basis of the flue gas
temperature measured.
If the flue gas temperature is below 50°C after 10 minutes (after closing the
combustion chamber door), the combustion air is closed again by the control
without further signals. The air control lever moves to the left.
Heat-up errors: flue gas temperature is above 50°C but the pre-set minimum
temperature for starting the control is not reached: If the flue gas tempera-
ture then drops below 50°C, the combustion air supply is closed for another
15 minutes. An audible signal sounds. Reasons for a heat-up error could be
that not enough, too much, too large or fuel that is too moist has been added,
or the water heat exchanger pipes are blocked.
If there is a heat-up error and the flue gas temperature continues to increase,
the combustion air supply is throttled depending on the exhaust gas temper-
ature. Thus, the primary air (flows over the grate in the combustion chamber)
is closed first and then the secondary air is reduced (differential combus-
tion air setting). In doing so, the combustion air lever moves from the right
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Spartherm Senso L at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Spartherm Senso L in the language / languages: English as an attachment in your email.

The manual is 3.7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Spartherm Senso L

Spartherm Senso L User Manual - German - 44 pages

Spartherm Senso L User Manual - Dutch - 53 pages

Spartherm Senso L User Manual - Dutch - 44 pages

Spartherm Senso L User Manual - French - 57 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info