744254
42
Zoom out
Zoom in
Previous page
1/53
Next page
GB 42
7. TROUBLESHOOTING
Problem Cause, explanation Chapter
note Solution
Glass becomes
sooted heavily,
rapidly and une-
venly.
You did not use the correct combusti-
on materials. 5. Use natural, bulky bits of timber compliant with 1st BImSchV §3 (German legislation).
The ambient temperature is above
about 15°C. The weather conditions
are unfavorable (e.g. fog). These wea-
ther conditions occur most frequently
in spring and fall.
4.5 Fill the fireplace with a small amount of fuel and light it with the damper fully open (max. air flow).
There is a temperature inversion. That
means that the upper layers of the atmo-
sphere are warmer than the lower layers.
4.5 Fill the fireplace with a small amount of fuel and light it with the damper fully open (max. air flow).
The combustion air controller is not
fully opened. 4.1.1 Move the air actuating lever into its far right-hand position.
The external combustion air line is
not free. 2.2.2.2 Clean the combustion air line.
Combustion air is too heavily
restricted. This means that soot accu-
mulates quickly, within just half an
hour. (it is normal for the fireplace unit
to become progressively dirtier from
operation of the system. When driving,
a car window becomes dirty, too!)
-Check the position of the air lever and, if necessary, open up the combustion air flow rate fully to bring the
fireplace unit up to operating temperature.
The seating of a gasket is not perfect. -Check all seals, e.g. open the fire door and press the seal fully into the door profile.
The wood is not dry enough. 5. Measure the residual humidity in the wood used with a humidity detector. The recommended residual humidity
is 20% or less.
Not enough wood has been added. (an
insufficient amount of wood can result
in temperatures in the stove not being
high enough).
4.2.2 The proper amount of wood feed per hour for your tiled stove can be found in the technical data.
The chimney draught is too strong /
too weak. -Observe the situation. The draught characteristics can be affected by the prevailing weather pattern. If the
glass continues to soot up badly, inform your chimney sweep.
Fire is difficult to
ignite
You did not use the correct combusti-
on materials. 5. Use natural, bulky bits of timber compliant with 1st BImSchV §3 (German legislation).
The wood is not dry enough. 5. Measure the residual humidity in the wood used with a humidity detector. The recommended residual humidity
is 20% or less.
The wood too thick. 5.
Use small-sized timber to light the fire. For firewood, use only split wood that is not thicker than about 8 cm
at its thickest point. The optimum length of firewood is approximately 20 - 25 cm. In the case of prolonged
heating, do not add too much wood. Instead, it is better to add smaller quantities of wood.
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Spartherm Piko H2O at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Spartherm Piko H2O in the language / languages: English as an attachment in your email.

The manual is 3.7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Spartherm Piko H2O

Spartherm Piko H2O Usermanual and installation guide - German - 52 pages

Spartherm Piko H2O Usermanual and installation guide - Dutch - 53 pages

Spartherm Piko H2O User Manual - Dutch - 44 pages

Spartherm Piko H2O Usermanual and installation guide - French - 53 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info