695381
20
Zoom out
Zoom in
Previous page
1/27
Next page
GB 20
6. HELP
Problem Cause, explanation Chapter, note Solution
Glass becomes
sooted heavily,
rapidly and
unevenly.
You did not use the correct combustion materials. 2. Use natural, bulky bits of timber compliant with BImSchV §3 (German legislation).
The ambient temperature is above about 15°C. The weather conditions are unfavorable
(e.g. fog). These weather conditions occur most frequently in spring and fall. 4.1 Fill the fireplace with a small amount of fuel and light it with the damper fully open
(max. air flow).
There is a temperature inversion. That means that the upper layers of the atmosphere
are warmer than the lower layers. 4.1 Fill the fireplace with a small amount of fuel and light it with the damper fully open
(max. air flow).
The combustion air controller is not fully opened. 3.2.1 Move the air actuating lever into its far right-hand position.
The external combustion air line is not free. 4.3 Clean the combustion air line.
Combustion air is too heavily restricted. This means that soot accumulates quickly,
within just half an hour. (it is normal for the fireplace unit to become progressively dirtier
from operation. When driving, a car window becomes dirty, too!)
3.2.1 Check the position of the air lever and, if necessary, open up the combustion air flow rate
fully to bring the fireplace unit up to operating temperature.
The seating of a gasket / door seal is not perfect. -Check all seals, e.g. open the fire door and press the seal fully into the door profile.
The wood is not dry enough. 2. Measure the residual humidity in the wood used with a humidity detector. The recom-
mended residual humidity is 20% or less.
Not enough wood has been added. (an insufficient amount of wood can result in temper-
atures in the stove not being high enough). 2.1.3 The proper amount of wood per hour can be found in the technical data.
The chimney draught is too strong / too weak. -Observe the situation. The draught characteristics can be affected by the prevailing
weather pattern. If the glass continues to soot up badly, inform your chimney sweep.
Fire is difficult to
ignite
You did not use the correct combustion materials. 2. Use natural, bulky bits of timber compliant with BImSchV §3 (German legislation).
The wood is not dry enough. 2. Measure the residual humidity in the wood used with a humidity detector. The recom-
mended residual humidity is 20% or less.
The wood too thick. 2.
Use small-sized timber to light the fire. For firewood, use only split wood that is not
thicker than about 8 cm at its thickest point. The optimum length of firewood is approx-
imately 20 - 25 cm. In the case of prolonged heating, do not add too much wood.
Instead, it is better to add smaller quantities of wood.
A sufficient air supply is not assured. 3. For heating or for adding more firewood, move the actuating lever fully to the right.
The ambient temperature is above about 15°C. The weather conditions are unfavorable
(e.g. fog). This is referred to as an intervening period. 4.1 Fill the fireplace with a small amount of fuel and light it with the damper fully open
(max. air flow).
There is a temperature inversion. That means that the upper layers of the atmosphere
are warmer than the lower layers. 4.1 Fill the fireplace with a small amount of fuel and light it with the damper fully open
(max. air flow).
The combustion air controller is not fully opened. 3.2.1 Move the air actuating lever into its far right-hand position.
The external combustion air line is not free. 4.3 Clean the combustion air line.
The chimney is not free. -Inform the chimney sweep.
There is not enough vacuum in the chimney. -Light a small fire in the fireplace, following advice from your fireplace installer or
chimney sweep.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Spartherm Linear Triple at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Spartherm Linear Triple in the language / languages: English as an attachment in your email.

The manual is 1.24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Spartherm Linear Triple

Spartherm Linear Triple User Manual - German - 27 pages

Spartherm Linear Triple User Manual - Dutch - 27 pages

Spartherm Linear Triple User Manual - French - 27 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info