663289
40
Zoom out
Zoom in
Previous page
1/109
Next page
English2
0 275 007 ADC | (1.4.16) Bosch eBike Systems
Assembly
Inserting and removing the battery pack
For inserting and removing the eBike battery pack in/from the
eBike, please read and observe the battery pack operating in-
structions.
Checking the Speed Sensor (see figure A)
The speed sensor 2 and its spoke magnet 3 must be mounted
in such a manner that the spoke magnet, after a turn of the
wheel, moves past the speed sensor with a clearance of at
least 5 mm, yet no more than 17 mm.
Note: If the distance between speed sensor 2 and spoke mag-
net 3 is too small or too large, or if the speed sensor 2 is not
properly connected, the speed indication will fail, and the
eBike drive unit will operate in emergency mode.
In this case, loosen the screw of the spoke magnet 3 and fas-
ten the spoke magnet to the spoke in such a manner that it
runs past the mark of the speed sensor at the correct clear-
ance. If the speed is still not being indicated in the speed indi-
cation after this, please contact an authorised bicycle dealer.
Operation
Initial Operation
Requirements
The eBike system can only be activated when the following
requirements are met:
A sufficiently charged battery pack is inserted (see battery
pack operating instructions).
The on-board computer is properly inserted in the holder
(see on-board computer operating instructions).
The speed sensor is connected properly (see “Checking
the Speed Sensor”, page English2).
Switching the eBike System On/Off
Options for switching on the eBike system:
If the on-board computer is already switched on when you
insert it into the holder, then the eBike system will be
switched on automatically.
With the on-board computer and the eBike battery pack in-
serted, briefly press the On/Off button of the on-board com-
puter (see on-board computer operating instructions).
When the on-board computer is inserted, press the On/Off
button of the eBike battery pack (see battery pack operat-
ing instructions).
The drive is activated as soon as you step on the pedals (ex-
cept when in the push aid feature, see “Switching the Push-
assistance mode On/Off”, page English3). The motor out-
put depends on the settings of the assistance level on the on-
board computer.
As soon as you stop pedaling when in normal operation, or as
soon as you have reached a speed of 25 km/h, the assistance
from the eBike drive is switched off. The drive is automatically
re-activated as soon you start pedaling again and the speed is
below 25 km/h.
Options for switching off the eBike system:
Press the On/Off button of the on-board computer.
Switch the eBike battery pack off by its On/Off button (see
battery pack operating instructions).
Remove the on-board computer out of its holder.
If the eBike is not moved and no button is pressed on the on-
board computer for 10 minutes, the eBike system will shut
down automatically in order to save energy.
eShift (optional)
eShift is the integration of automatic gear shifting systems in-
to the eBike system. The eShift components are electrically
connected to the drive unit by the manufacturer. The opera-
tion of automatic gear shifting systems is described in the op-
erating instructions of the on-board computer.
Setting the Assistance Level
On the on-board computer you can set how much the eBike
drive assists you while pedalling. The assistance level can be
changed at any time, even while cycling.
Note: For individual versions, it is possible that the assistance
level is pre-set and cannot be changed. It is also possible that
less assistance levels are available for selection than listed
here.
The following assistance levels (max.) are available:
“OFF: The motor assistance is switched off, and the eBike
can be moved as a normal bicycle only by pedalling. The
push assistance cannot be activated in this assistance level.
“ECO”: Effective assistance at maximum efficiency for
maximum cruising range
“TOUR”: Uniform assistance, for touring with long cruising
range
“SPORT”: Powerful assistance for sportive riding off road
as well as for urban traffic
“TURBO”: Maximum assistance, supporting highest ca-
dence for sportive riding
The requested motor output appears on the display of the on-
board computer. The maximum motor output depends on the
selected assistance level.
Assistance Level Assistance Factor*
“ECO” 40%
“TOUR” 100%
“SPORT” 150%
“TURBO” 250 %
* The motor output can vary for individual versions.
OBJ_BUCH-2793-001.book Page 2 Friday, April 1, 2016 9:50 AM
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sparta M7B - 2016 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sparta M7B - 2016 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 46,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info