611462

Soundcraft Vi 6 Manual

321
Zoom out
Zoom in
Previous page
1/337
Next page
Soundcraft Vi Series™ User Guide 1112Page 25 - 14
TROUBLESHOOTING A VM
2
SETUP
Problem
HiQnet cannot be switched ON in the Menu-System-HiQnet page because there is no IP address.
Solution
1. Check the cable connection to the HiQnet port on the console – if there is no valid Ethernet connection,
it will not be possible to switch on the HiQnet functionality.
2. Assuming cable connection is OK, if DHCP mode is selected on the console, check that the router that
is being used has a DHCP server capability and that this is enabled in the router setup.
3. It is possible to connect the console directly to the Hub4000 without a router, with the console set
to DHCP mode. In this case there will be a considerable delay (up to 60 secs) before an IP address is
allocated, as this has to be negotiated between the console and the Hub.
4. If using a manually set address, the console’s IP address must have the same subnet mask as the
Hub4000Q, so System Architect must be used to discover what that is. Once the address is known, set the
console to a different address but with the same subnet mask.
Problem
No AKG receivers are detected by the console – the list on the HiQnet page is empty
Solution
1.Check that all AKG receivers are connected to the Hub4000Q, the Hub4000Q front panel LEDs show
connection status of the attached receivers, and there is a network connection between the Hub4000Q
and the console (via a network switch if necessary)
2. Check that the IP Cong of the console and the Hub4000Q match – if using a router with DHCP server
and you do not want to use a manually set IP address, make sure the console is set to ‘DHCP’ mode in the
Menu-System-HiQnet page.
Problem
The AKG receivers are listed in the Device list on the HiQnet page are greyed out.
Solution
This indicates that there is a network connection has previously existed correctly but there is now a
connection error – either the Hub4000Q has been disconnected or switched off, or there is another
connection problem between the Hub and desk or router and desk. Check all network connections.
… 321 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Soundcraft Vi 6 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Soundcraft Vi 6 in the language / languages: English as an attachment in your email.

The manual is 10,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info