611469

Soundcraft Signature 22 Manual

35
Zoom out
Zoom in
Previous page
1/55
Next page
16, 22, 22MTK User Manual
5.1.1: MONO INPUT CONTROLS
CHANNEL CONTROLS > MONO INPUT CONTROLS
5.1.1: MONO INPUT CONTROLS
PEAK & MUTE LED
Lights when signal reaches peak level or shows that the channel is muted
The Peak LED is a warning light to let you know when the signal is nearing maximum headroom. The peak
detection source is taken from a number of key points in the signal path (see section 4.1) where gain is used: After
the High Pass Filter, post EQ, and post Fade. If a signal is amplified past the limits of the console's headroom, then
'clipping' (noise) will occur.
PFL
Route the signal to the Solo bus and mute any channels not routed to the Solo bus
With a PFL enabled, the headphone output will switch to the Solo Bus. Please see section 6 for more detail.
FADER
Adjust signal level
The Fader adjusts level between -infinity (no signal) to +10dB. The 0dB line indicates unity (no level change).
Faders are the primary mixing tools during performance; the relative levels of the input channel faders across the
console determine the Master Stereo (MST) and Group (GRP) mixes, as well as providing the source for post-fade
Aux mixes.
MST
Route the channel output to the Master left/right bus
The Pan/Balance controls proportion the signal to the left and right Master bus channels.
GRP 1-2 / 3-4
Route the channel output to Group busses
The channel's PAN control determines the proportion of the signal across group pairs.
… 35 …


Need help? Post your question in this forum.

Forumrules
1

Forum

soundcraft-signature-22

Reset search

  • I've got the Signature 22 Multi-Track. i was experiencing bad static thru my phones using my ART headphone amp. I believed the amp had gone bad, so, I replaced all the cables, and purchased a new Mackie headphone amp. after install in my rack, with new cables...I still have the issue. Any suggestions? Dirty Pot?, or that channel has simply died. any workarounds would be helpful. thanks G.N. Submitted on 19-2-2022 at 22:14

    Reply Report abuse

  • I have really bad static coming from headphone out. I have replaced all cables, and bought a new Mackie Headphone amp, believing my old amp had gone bad. after setting up headphone amp, I have the same issue. sound to my monitors is perfect. Help would be appreciated. I'm stumped Submitted on 19-2-2022 at 22:09

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Soundcraft Signature 22 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Soundcraft Signature 22 in the language / languages: English as an attachment in your email.

The manual is 7,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info