611445
22
Zoom out
Zoom in
Previous page
1/48
Next page
USER GUIDE
20
9
FADER
The 100mm FADER gives you smooth control of the overall signal level in the channel strip, allowing precise
balancing of the various source signals being mixed to the Master Section. It is important that the input
level is set correctly to give maximum travel on the fader which should normally be used at around the `0’
mark. See the `Initial Set Up’ section on page 23 for help in setting the right level.
0
PFL
When the latching PFL switch is pressed, the pre-fade signal is fed in mono to the headphones, control
room output and meters, where it replaces the MIX. The PFL/AFL LED on the Master section illuminates to
warn that a PFL is active. The Left and Right meters display the PFL signal in mono. This is a useful way of
listening to any required input signal without interrupting the main mix, for making adjustments or tracing
problems.
q
RETURN PEAK LED
This LED will light when the return input signal peaks (+18dBu internal).
w
CHANNEL PEAK LED
This LED will light when the signal peaks (+18dBu internal). There is a three point signal analysis, and if the
signal peaks at any of these points then the LED will light:
a) PRE-EQ
b) POST-EQ
c) POST-FADE
e
SIGNAL PRESENT LED
This LED will light when the channel signal exceeds -20dBu.
r
AUX OUTPUTS (1-4)
These outputs are on 3-pole A gauge jacks and are balanced outputs
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Soundcraft M4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Soundcraft M4 in the language / languages: English as an attachment in your email.

The manual is 4,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Soundcraft M4

Soundcraft M4 User Manual - German - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info