611447

Soundcraft M12 Manual

32
Zoom out
Zoom in
Previous page
1/48
Next page
USER GUIDE
30
CARE OF YOUR MIXER
GENERAL PRECAUTIONS
• Do Not obstruct any of the ventilation openings.
• Avoid storing or using the mixer in conditions of excessive heat or cold, or in positions where it is likely
to be subject to vibration, dust or moisture.
• Keep the mixer clean using a soft dry brush, and an occasional wipe with a damp cloth or ethyl
alcohol. Do not use any other solvents which may cause damage to paint or plastic parts.
• Avoid placing drinks or smoking materials on or near the mixer. Sticky drinks and cigarette ash are
frequent causes of damage to faders and switches.
• Regular care and inspection will be rewarded by a long life and maximum reliability.
GLOSSARY
AFL (After Fade Listen) a function that allows the operator to monitor the post-fade signal in a channel
independently of the main mix.
auxiliary send an output from the console comprising a mix of signals from channels and groups
derived independently of the main stereo/group mixes. Typically the feeds to the
mix are implemented on rotary level controls.
balance the relative levels of the left and right channels of a stereo signal.
balanced a method of audio connection which ‘balances’ the wanted signal between two
wires and a screen which carries no signal. Any interference is picked up equally
by the two wires, which results in cancellation of the unwanted signal. In this guide,
the term can refer to various circuit architectures. Connection details are
given in relevant sections.
clipping the onset of severe distortion in the signal path, usually caused by the peak signal
voltage being limited by the circuit’s power supply voltage.
DAT Digital Audio Tape, a cassette-based digital recording format.
dB (decibel) a ratio of two voltages or signal levels, expressed by the equation dB=20Log10
(V1/V2). Adding the suffix ‘u’ denotes the ratio is relative to 0.775V RMS.
DI(direct injection) the practice of connecting an electric musical instrument directly to the input of the
/DI Box mixing console, rather than to an amplifier and loudspeaker which is covered by a
microphone feeding the console.
direct output a post fade line level output from the input channel, bypassing the summing
amplifiers, typically for sending to individual tape tracks during recording.
equaliser a device that allows the boosting or cutting of selected bands of frequencies in the
signal path.
fader a linear control providing level adjustment.
feedback the `howling’ sound caused by bringing a microphone too close to a loudspeaker
driven from its amplified signal.
foldback a feed sent back to the artistes via loudspeakers or headphones to enable them to
monitor the sounds they are producing.
frequency response the variation in gain of a device with frequency.
gain the amount of amplication in level of the signal.
headroom the available signal range above the nominal level before clipping occurs.
highpass filter a filter that rejects low frequencies.
impedance balancing a technique used on unbalanced outputs to minimise the effect of hum and
interference when connecting to external balanced inputs.
insert a break point in the signal path to allow the connection of external devices, for
instance signal processors or other mixers at line level signals. Nominal levels can
be anywhere between -10dBu to +6dBu, usually coming from a low impedance
source.
pan (pot) abbreviation of ‘panorama’: controls levels sent to left and right outputs.
peaking the point at which a signal rises to its maximum instantaneous level, before falling
back down again. It can also describe an equaliser response curve affecting only a
band of frequencies, (like on a graphic equaliser), “peaking” at the centre of that
band.
… 32 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Soundcraft M12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Soundcraft M12 in the language / languages: English as an attachment in your email.

The manual is 4,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Soundcraft M12

Soundcraft M12 User Manual - German - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info