23504
30
Zoom out
Zoom in
Previous page
1/40
Next page
30
Rear Panel GigRac 300Rear Panel GigRac 300
Rear Panel GigRac 300Rear Panel GigRac 300
Rear Panel GigRac 300
(1) Power Switch
This switch turns the GigRac On or Off. The red Power LED (13) on the
front panel will illuminate to confirm this.
NB! Before switching the GigRac On or Off, make sure
that the Main and Mon Master Volume controls are
turned fully down.
(2) Power Socket
Connect the supplied power cable to this socket.
(3) Speakers Outputs
The Speaker Outputs are available as Neutrik Speakon connectors and
standard ¼” Jack connectors.
Connect your loudspeakers to these outputs. The signal sent to the
Speakon connectors and the Jack sockets is exactly the same.
Use the appropriate connector type to match the input connectors on
your loudspeakers.
The minimum load that the amplifier inside the GigRac should be presented
with is 4 ohms. This means that a single 8 ohm speaker can be connected
to each of the speaker outputs as shown in Fig1, or two 8 ohm speakers
can be connected in parallel to one of the speaker outputs as shown in
Fig 2. Two speakers connected like this gives a combined load of 4
ohms.
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Soundcraft Gicrac600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Soundcraft Gicrac600 in the language / languages: English as an attachment in your email.

The manual is 2,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Soundcraft Gicrac600

Soundcraft Gicrac600 User Manual - German - 40 pages

Soundcraft Gicrac600 User Manual - French - 40 pages

Soundcraft Gicrac600 User Manual - Italian - 40 pages

Soundcraft Gicrac600 User Manual - Spanish - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info