24771
10
Zoom out
Zoom in
Previous page
1/32
Next page
10
1. Connecting up your loudspeakers to the GigRac
Note: Make sure your GigRac is not powered up. This
is very important to prevent any damage to either the
GigRac or your loudspeakers!
Using good quality speaker cables connect the loudspeakers to the
Speaker outputs on the rear of the GigRac.
If you have cables equipped with Neutrik Speakon® connectors then use
the Speakon® connectors on the rear of the GigRac. Alternatively if
you have cables equipped with jack plugs then use the jack sockets on
the rear of the GigRac.
Make sure that the Main Master Volume control (1 - see the key on
page 9) and the Monitor (Mon) Master Volume control (2) are turned
fully down.
Decide if you want to configure the 2 internal amplifiers to work as a
stereo pair, or mono mix and monitor. Set the amplifier source select
switch (3) as desired. It is assumed in these quick start instructions
that you have configured the amps as a stereo pair.
Now switch the GigRac on using the Power switch on the rear of the
unit.
2. Plugging in a vocal microphone
Note: Before connecting a microphone to channels 1-4,
make sure that the 48V phantom power switch (4) is
switched off (The red LED should not be illuminated).
Connect the microphone cable to one of the first four inputs on the
front of the GigRac (5).
(The inputs on the GigRac can receive either 3-Pin XLR or standard
Jack connectors.)
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Soundcraft Gicrac1000st at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Soundcraft Gicrac1000st in the language / languages: English as an attachment in your email.

The manual is 2,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info