215120
34
Zoom out
Zoom in
Previous page
1/152
Next page
GB
34
Troubleshooting
Others
Others
This section describes how to solve the problems, how to
replace a lamp and air filter, etc.
Troubleshooting
Symptom Cause and Remedy
The power is not turned on. The power has been turned off and on with the [/ 1 (on/standby) switch at a
short interval.
c Wait for about one minute before turning on the power (1 page 15).
The lamp cover is detached.
c Close the lamp cover securely (1 page 38).
The air filter cover is detached.
c Close the air filter cover securely (1 page 39).
No picture. Cable is disconnected or the connections are wrong.
c Check that the proper connections have been made (1 pages 8 and 9).
Input selection is incorrect.
c Select the input source correctly using the INPUT button (1 page 15).
The computer signal is not set to output to an external monitor.
c Set the computer signal to output to an external monitor.
The computer signal is set to output to both the LCD of the computer and
external monitor.
c Set the computer signal to output only to the external monitor.
The picture from the PJ MULTI
connector is colored strange.
Setting for INPUT-A in the SET SETTING menu is incorrect.
c Select COMPUTER, COMPONENT or VIDEO GBR for INPUT-A in the
SET SETTING menu according to the input signal (1 page 20).
Color balance is incorrect. Picture has not been adjusted properly.
c Adjust the picture in the PICTURE CTRL menu (1 page 19).
Projector is set to wrong color system.
c Set COLOR SYS in the PICTURE CTRL menu to match the color
system being input (1 page 19).
The picture is too dark. Contrast or brightness has not been adjusted properly.
c Adjust the contrast or brightness in the PICTURE CTRL menu properly
(1 page 19).
The picture is not clear. Picture is out of focus.
c Adjust the focus with the focus lever (1 page 15).
The lens cap is attached to the lens.
c Remove the lens cap.
Condensation has occurred on the lens.
c Leave the projector for about two hours with the power on.
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony vpl hs1 lcd svga 700alu 120w at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony vpl hs1 lcd svga 700alu 120w in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 4,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info