543136
23
Zoom out
Zoom in
Previous page
1/56
Next page
23
The Operation Menu
Adjustments and Settings Using a Menu
The Operation Menu
The Operation Menu is used for setting for the operations by using the menu or the Remote
Commander.
*1: Available for VPL-FH35/FH30 only
*2: You will not be able to use the projector if you forget your password. If you call qualified Sony
personnel because you have forgotten the password, you will be asked to verify the projector’s
serial number and your identity. (This process may differ in other countries/regions.) Once your
identity has been confirmed, we will provide you with the password.
Setting items Description
Language Selects the language used in the menu and on-screen displays.
Menu Position
*1
Bottom Left/Center: For selecting the position of the menu displayed on the
projected image.
Status On: All on-screen statuses are enabled.
Off: Turn off the on-screen displays except for the menus, message when
turning off the power, and warning messages.
IR Receiver Front & Rear/Front/Rear: Selects the remote control detectors (IR Receiver)
on the front and rear of the projector.
ID Mode All/1/2/3: Assigns an ID number to the projector. When set to “All,” you can
control the projector with the Remote Commander independently of the
assigned ID Mode. Refer also to “ID MODE 1/2/3 switch” of the Remote
Commander on page 7.
Security Lock
*2
On/Off: This function enables restriction of the projector to autherized users
by password. The setting procedures for security locking are as follows:
1 Select “On” then press the ENTER key to display the setting menu.
2 Input the password with the MENU, V/v/B/b, and ENTER keys. (The
default password setting is “ENTER, ENTER, ENTER, ENTER.)
3 Input a new password with the MENU, V/v/B/b, and ENTER keys.
4 Enter the password again to confirm.
Enter the password when you turn on the projector after disconnecting and
reconnecting the AC power cord.
When it is set to “Off,” you can cancel the security lock. You are required to
input the password again.
If you fail to enter the correct password after three consecutive times, the
projector cannot be used. In this case, press the ?/1 key to go Standby mode
then turn on the power again.
Panel Key Lock On/Off: When set to “On,” locks all the control panel keys of the projector.
However, you can enable operation by performing the following even when
“Panel Key Lock” is set to “On.
Press and hold the ?/1 key for approximately 10 seconds during Standby
mode.
c The projector turns on.
Press and hold the MENU key for approximately 10 seconds during power
on.
c Panel Key Lock” is set to “Off” and enables operation of all control panel
keys on the projector.
Notes
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony VPL-FH35 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony VPL-FH35 in the language / languages: English as an attachment in your email.

The manual is 1,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info