532259
50
Zoom out
Zoom in
Previous page
1/68
Next page
50
There is no sound from one of the front
speakers.
Connect a pair of headphones to the PHONES
jack to verify that sound is output from the
headphones (see page 26).
If only one channel is output from the
headphones, the component may not be
connected to the receiver correctly. Check that
all the cords are fully inserted into the jacks on
both the receiver and the component.
If both channels are output from the headphones,
the front speaker may not be connected to the
receiver correctly. Check the connection of the
front speaker which is not outputting any sound.
There is no sound or only a very low-level sound
is heard.
Check that the speakers and components are
connected securely.
Check that you have selected the correct
component on the receiver.
Check that the SPEAKERS switch is set to ON
(see page 26).
Check that the headphones are not connected.
Press MUTING if muting function is activated.
The protective device on the receiver has been
activated because of a short circuit. Turn off the
receiver, eliminate the short-circuit problem and
turn on the power again.
When only a very low-level sound is heard,
check to see if NIGHT MODE is activated (see
page 31).
The left and right sounds are unbalanced or
reversed.
Check that the speakers and components are
connected correctly and securely.
Adjust balance parameters in the LEVEL menu.
There is severe hum or noise.
Check that the speakers and components are
connected securely.
Check that the connecting cords are away from a
transformer or motor, and at least 3 meters away
from a TV set or fluorescent light.
Move your TV away from the audio components.
Make sure you have grounded U SIGNAL GND
terminal (only when a turntable is connected).
The plugs and jacks are dirty. Wipe them with a
cloth slightly moistened with alcohol.
There is intermittent sound from a digital source.
Check to see if signals with 96 kHz sampling
frequencies are input to the DVD/LD OPTICAL
IN or COAXIAL jacks.
There is no sound from the center speaker.
Make sure the sound field function is on (press
MODE +/–).
Select a sound field containing the word
“CINEMA” or “VIRTUAL” (see page 28–30).
Adjust the speaker level (see page 35).
Make sure the center speaker size parameter is
set to either “SMALL” or “LARGE” (see page
20).
There is no sound or only a very low-level sound
is heard from the surround/surround back
speakers.
Make sure the sound field function is on (press
MODE +/–).
Select a sound field containing the word
“CINEMA” or “VIRTUAL” (see page 28–30).
Adjust the speaker level (see page 35).
Make sure the surround/surround back speaker
size parameter is set to either “SMALL” or
“LARGE” (see pages 20–21).
There is no sound from the active sub woofer.
There is no sound output from the SUB
WOOFER terminal depending on the sound field
(see page 59).
The surround effect cannot be obtained.
Make sure the sound field function is on (press
MODE +/–).
Dolby Digital or DTS multi channel sound is not
reproduced.
Check that the playing DVD, etc. is recorded in
Dolby Digital or DTS format.
When connecting the DVD player, etc. to the
digital input jacks of this receiver, check the
audio setting (settings for the audio output) of the
connected component.
Troubleshooting (continued)
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony STR-DB1070 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony STR-DB1070 in the language / languages: English as an attachment in your email.

The manual is 0,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info