656504
22
Zoom out
Zoom in
Previous page
1/28
Next page
22
GB
If a LAN cable is connected to the unit,
disconnect it and restart the unit. When a LAN
cable is connected to the unit, the unit
automatically tries to connect to the home
network over a wired network and a wireless
network cannot be used.
Check that your wireless router is turned on.
Bring the unit and wireless router closer
together. Devices that use the 2.4 GHz
frequency band, such as a microwave oven,
BLUETOOTH or digital cordless device, etc.,
may interrupt Wi-Fi communication. Move the
unit away from such devices or turn them off.
Set the Wi-Fi antenna (aerial).
If a Wi-Fi network is not possible even if the
setting of a Wi-Fi network is correct, try the
following.
Turn off the wireless router/access point,
wait a while and turn on the power again.
Turn off the unit, wait a while and turn on
the power again.
Distorted sound/humming or noise in the
unit output
Turn down the volume of the connected
device.
If a connected device has an equalizer
function, turn it off.
Keep the unit away from a microwave oven,
other wireless devices, etc.
Keep the unit away from metal objects.
Connect the unit and wireless router/PC via a
LAN cable, not via Wi-Fi network.
No sound/low sound level
Check that both the unit and connected
device are turned on.
Turn up the volume of the unit and the
connected device.
Check that the connected device is being
played back.
iTunes cannot find the unit via AirPlay
Make sure the PC with iTunes installed and the
unit are connected to the same home
network.
Update the software version of iTunes to the
latest version.
/ (on/standby) indicator is flashing red
A software update is failed, or the unit is in the
protect mode. Check the following to resolve
the problem.
The UPDATE button is flashing in orange.
Software update is failed. Update the
software using a USB flash drive. Check the
customer support website about how to
update the software with a USB flash drive.
Turn off the unit until you perform the
software update.
The unit does not turn off by tapping the /
(on/standby) button.
The unit is in the protect mode. Unplug the
AC power cord of the unit, and unplug all
other items connected to the unit. Then,
plug the AC power cord in again and turn
on the unit. If the / (on/standby)
indicator keeps flashing, consult your
nearest Sony dealer or the shop where you
purchased this unit.
The last setting is not kept
If the AC power cord (mains lead) is
disconnected while the unit is on, the last
usage setting before disconnecting the AC
power cord (mains lead) is not kept. Turn off
the power of the unit, and then unplug the AC
power cord (mains lead).
The unit has entered standby mode or
BLUETOOTH/Network standby mode
unexpectedly
This is not a malfunction. The unit enters
standby mode or BLUETOOTH/Network
standby mode automatically due to the auto
standby function if no operation is performed
and no sound is input for about 15 minutes.
Refer to Help Guide for details about the auto
standby function.
To check Wi-Fi signal strength
(reception sensitivity)
While the unit is connected to the Wi-Fi
network, tap and hold the NETWORK button
until you hear a beep.
General
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony SRS-X99 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony SRS-X99 in the language / languages: English as an attachment in your email.

The manual is 3,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sony SRS-X99

Sony SRS-X99 User Manual - German, Dutch, French, Italian, Spanish - 143 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info