47877
20
Zoom out
Zoom in
Previous page
1/321
Next page
20
Picture flickers, bounces,
oscillates, or is scrambled
Adjust the pitch and phase (SDM-S73E/S74E analog RGB signal only) (page 13).
Try plugging the monitor into a different AC outlet, preferably on a different circuit.
Change the orientation of the monitor.
x Problems caused by a computer or other equipment connected, and not
caused by the monitor
Check your graphics board manual for the proper monitor setting.
Confirm that the graphics mode (VESA, Macintosh 19" Color, etc.) and the frequency of
the input signal are supported by this monitor. Even if the frequency is within the proper
range, some graphics boards may have a sync pulse that is too narrow for the monitor to
sync correctly.
This monitor does not process interlace signals. Set for progressive signals.
Adjust the computer’s refresh rate (vertical frequency) to obtain the best possible picture.
Picture is fuzzy Adjust the brightness and contrast (page 12).
Adjust the pitch and phase (SDM-S73E/S74E analog RGB signal only) (page 13).
x Problems caused by a computer or other equipment connected, and not
caused by the monitor
Set the resolution to 1280 × 1024 on your computer.
Picture is ghosting Eliminate the use of video cable extensions and/or video switch boxes.
Check that all plugs are firmly seated in their sockets.
Picture is not centered or sized
properly (SDM-S73E/S74E analog
RGB signal only)
Adjust the pitch and phase (page 13).
Adjust the picture position (page 14). Note that some video modes do not fill the screen to
the edges.
Picture is too small x Problems caused by a computer or other equipment connected, and not
caused by the monitor
Set the resolution to 1280 × 1024 on your computer.
Picture is dark Adjust the backlight (page 12).
Adjust the brightness (page 12).
Adjust the gamma using GAMMA menu (page 15).
It takes a few minutes for the display to become bright after turning on the monitor.
The screen might turn darker, depends on ECO mode you selected.
Wavy or elliptical pattern (moire)
is visible
Adjust the pitch and phase (SDM-S73E/S74E analog RGB signal only) (page 13).
Color is not uniform Adjust the pitch and phase (SDM-S73E/S74E analog RGB signal only) (page 13).
White does not look white Adjust the color temperature (page 14).
Monitor buttons do not operate
( appears on the screen)
If MENU LOCK is set to ON, set it to OFF (page 16).
The monitor turns off after a while xProblems caused by the connected computer or other equipment
Set the computer’s power saving setting to off.
Resolution displayed on the menu
screen is incorrect
Depending on the graphics board setting, the resolution displayed on the menu screen may
not coincide with the one set on the computer.
After turning off the main power,
the 1 (power) indicator stays
bright for a while
When the main power is on but the 1 (power) switch is not pressed, or when the monitor
is in the power saving mode, if you turn the MAIN POWER switch off, the 1 (power)
indicator may not turn off right away. This is not a malfunction.
Symptom Check these items
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony SDM-S73E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony SDM-S73E in the language / languages: English, German, Dutch, French, Italian, Polish, Swedish, Spanish as an attachment in your email.

The manual is 7,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info