23382
76
Zoom out
Zoom in
Previous page
1/119
Next page
76
A new group cannot
be created.
This is due to the MiniDisc system limitations (in MD mode only).
Group information has been written to the area where the disc name is
stored. The disc name and track names are recorded in the same area,
which can store a maximum of approximately 1,700 characters. If the
total number exceeds this amount, it is impossible to make group
settings.
While the recorder is connected to the computer
Symptom Cause/Remedy
The recorder is not
recognized by the
computer.
The supplied USB cable is not firmly connected.
, Connect the USB cable firmly to the recorder and the computer.
A USB hub is used.
, Connect the USB cable directly to the USB port of the computer.
Network communication has failed.
, Disconnect the USB cable, wait at least 2 seconds, and then
reconnect it. If the recorder is still not recognized, disconnect the
USB cable, restart the computer, and then connect the USB cable
again.
When using Windows 2000 Professional, you turned on or restarted
the computer while the supplied USB cable was connected, and then
disconnected it afterwards.
, Disconnect the USB cable, restart the computer, and then
reconnect the USB cable. This problem may be resolved by
updating your Windows operating system so that it contains all
the latest features.
Charging by USB bus
power cannot be done
( flashes in the
display).
The battery compartment lid is not firmly closed.
, Reinsert the rechargeable battery and close the battery
compartment lid firmly.
The temperature of the battery-charging location is too low or too
high.
, Charge the rechargeable battery within a temperature range of
+5°C (+41°F) to +35°C (+95°F).
The rechargeable
battery cannot be
charged sufficiently
through USB bus
power.
The rechargeable battery is charged through USB bus power.
, USB bus power only charges temporary and cannot charge the
rechargeable battery sufficiently. Disconnect the recorder from the
computer and charge the rechargeable battery using the AC power
adaptor.
Even though the
recorder is recognized
by the computer, it
does not operate
normally.
A USB hub is used.
, Connect the supplied USB cable directly to the USB port of the
computer.
You are using the recorder at a place with vibration.
, Use the recorder at a place with no vibration.
The recorder cannot
be used as a storage
device.
The SonicStage or MD Simple Burner software is active.
, Close the SonicStage or MD Simple Burner software.
A disc which is not used in Hi-MD mode is inserted.
, Insert a disc used in Hi-MD mode. Only discs used in Hi-MD
mode can be used as a storage media.
Symptom Cause/Remedy
76


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony MZM100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony MZM100 in the language / languages: English as an attachment in your email.

The manual is 3,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info