23382

Sony MZM100 Manual

73
Zoom out
Zoom in
Previous page
1/119
Next page
73
Recording cannot be
done correctly.
• Recording may not be done if the remaining recordable time on the
disc is 48 seconds or less (“DISC FULL” appears).
, Replace the disc.
The lid does not open
after recording.
• The lid does not open until “SYSTEM FILE WRITING” disappears
in the display.
“TRACK FULL”
appears even before the
disc has reached the
maximum recording
time and the recording
cannot be done.
• This is due to the MiniDisc system limitation. When 2,047 tracks (on
a disc used in Hi-MD mode) have been recorded on the disc,
“TRACK FULL” appears regardless of the total recorded time. More
than 2,047 tracks cannot be recorded on the disc.
, To continue recording, erase unnecessary tracks.
The remaining
recording time does not
increase even after
erasing numerous short
tracks.
• This is due to the MiniDisc system limitation (in MD mode only).
Tracks of under 12 seconds (in SP mode), 24 seconds (in LP2 mode
or monaural), or 48 seconds (in LP4 mode) in length are not counted
and so erasing them may not lead to an increase in the recording
time.
The total recorded time
and the remaining time
on the disc may not total
the maximum recording
time (60, 74, or 80
minutes).
• This is due to the MiniDisc system limitation (in MD mode only).
Normally, recording is done in minimum units of approximately 2
seconds (in SP mode), 4 seconds (in LP2 mode or monaural), or 8
seconds (in LP4 mode). When recording is stopped, the last unit of
recording always uses this unit of 2 seconds, 4 seconds, or 8 seconds
even if the actual recording is shorter. Likewise, when recording is
restarted after the stop, the recorder will automatically insert a blank
space amounting to 2 seconds, 4 seconds, or 8 seconds before the
next recording. (This is to prevent accidental erasing of a previous
track whenever a new recording is started). Therefore, the actual
recording time will decrease whenever a recording is stopped by a
maximum of 6 seconds, 12 seconds, or 24 seconds.
“TRACK FULL”
appears even before the
disc has reached the
maximum track number
or recording time.
• This is due to the MiniDisc system limitation. Repeated recording
and erasing may cause fragmentation and scattering of data.
Although those scattered data can be read, each fragment is counted
as a track. In this case, the number of tracks may reach 2,047 (on a
disc used in Hi-MD mode) and further recording is not possible.
, To continue recording, erase unnecessary tracks.
Symptom Cause/Remedy
While playing
Symptom Cause/Remedy
A disc is not played
normally.
• Repeat play is selected.
, Set the Repeat play to “Off” to change back to the normal play
(page 42).
• Playback mode is changed.
, Enter the Main play mode or Sub play mode to change back to
the normal play (page 40).
A disc is not played from
the first track.
• Disc playing stopped before it came to the last track.
, Press the jog dial (N/ENT) on the recorder or press NX on
the remote control for 2 seconds or more to start playing.
… 73 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony MZM100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony MZM100 in the language / languages: English as an attachment in your email.

The manual is 3,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info