157183
16
Zoom out
Zoom in
Previous page
1/64
Next page
16
Notes
The pause function cannot be turned on or off
manually during synchro-recording. Press x
to stop recording.
Do not change “SYNC-R” setting while
recording. Recording may not be done
properly.
Even when there is no recorded sound on the
sound source, there may be cases when
recording does not pause automatically during
synchro-recording due to the noise level
emitted from the sound source.
If a silent portion is encountered for
approximately 2 seconds during synchro-
recording from a sound source other than a
CD or an MD, a new track mark is
automatically added at the point where the
silent portion ends.
Synchro-recording cannot be done if the
connecting cord is not an optical cable.
You cannot change the recording mode during
recording.
“Saving” or “Edit” flashes while data of the
recording (the track’s start and end points,
etc.) is being recorded. Do not move the
recorder or disconnect the power source while
the indication is flashing in the display.
The lid does not open until “Edit” disappears
in the display.
If the power supply is disrupted (i.e. the
battery is removed or becomes exhausted or
the AC power adaptor is disconnected) during
a recording or editing operation, or while
“Edit” appears in the display, then it will not
be possible to open the lid until power is
restored.
You can make a digital recording only from an
optical type output.
When recording from a portable CD player,
set the CD player to pause, and then do the
recording procedure on the recorder.
Note the following when recording from a
portable CD player:
—Some portable CD players may not be
capable of digital out when the AC power
adaptor is disconnected. If this is the case,
connect the AC power adaptor to the
portable CD player and use it on AC power
as the power source.
—On some portable CD players, optical
output may not be possible when using an
anti-skip function (e.g., ESP* or G-
PROTECTION). If this is the case, turn off
the anti-skip function.
Electronic Shock Protection
z
When there is no sound (page 60) from the
player for more than 3 seconds during
synchro-recording, the recorder goes into the
standby mode automatically. When the sound
comes from the player again, the recorder
resumes synchro-recording. If the recorder is
kept in the standby mode for 5 minutes or
longer, the recorder stops automatically.
For MDLP recording, follow steps 1 to 3 of
“Long-time recording (MDLP)” (page 21) to
select the recording mode, and then start the
procedure of synchro-recording.
LINE IN (OPTICAL) jack is for both digital
and analog input. The recorder automatically
recognizes the type of line cable and switches
to digital or analog input.
The recording level is adjusted automatically.
To adjust the level manually, see “Adjusting
the recording level manually (Manual
Recording)” (page 26).
You can monitor the sound during recording.
Connect the headphones/earphones to i and
adjust the volume by pressing VOL +, –. This
does not affect the recording level.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony mz-r410 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony mz-r410 in the language / languages: English as an attachment in your email.

The manual is 0,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sony mz-r410

Sony mz-r410 User Manual - German - 72 pages

Sony mz-r410 User Manual - Dutch - 68 pages

Sony mz-r410 User Manual - French - 68 pages

Sony mz-r410 User Manual - Italian - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info