159702
15
Zoom out
Zoom in
Previous page
1/138
Next page
Chapter 4: Recording on MDs
GB
15
Notes on Recording
When “TOC” flashes in the display
Do not move the unit or pull out the mains
lead. The MD deck is updating the Table Of
Contents (TOC).
Changes to an MD made through recording
are saved only when you update the TOC
by ejecting the MD or by pressing POWER
to switch the MD deck to standby.
Do not disconnect the main lead
immediately after recording
If you do so, the recorded sound may not
be saved to the MD.
If “Auto Cut” appears in the display
(auto cut)
There has been no sound input for
30 seconds while recording from a CD. The
30 seconds of silence are replaced by a
blank of about 3 seconds and the MD deck
changes to recording pause.
If “Smart Space” appears in the
display (smart space)
There has been an extended silence of 4 to
30 seconds in length while recording from a
CD. The silence is replaced with a blank of
about 3 seconds and the MD deck continues
recording. However, a new track number
may not be written during these 3 seconds.
If “REC LEVEL OVER” appears in the
display while recording from audio
equipment connected to this unit's
TAPE IN jacks
This message is displayed because a high-
level signal was input during analog
recording. If the sound is distorted, re-
record the sound source again according to
the following procedure.
1 Press EDIT/NO repeatedly during
recording or recording pause until
“Attenuate ?” appears in the display.
2 Press ENTER/YES.
“Attenuate ON?” appears in the display.
3 Press ENTER/YES again.
The ATTENUATE indicator lights up.
4 Re-record the sound.
The recording level is reduced.
Note
Once you change the setting, it is stored in
the unit. Be sure to release this setting after
recording.
To release this setting
Repeat steps 1 to 4, and confirm that
“Attenuate OFF?” is displayed in step 2.
To protect the recorded sound
To make it impossible to record on an MD,
slide the tab in the direction of the arrow to
3 Press CD SYNCHRO
The unit enters CD play pause mode.
The “REC PAUSE” indicator flashes, the
MD deck stands by for recording, and
the CD player stands by for playback.
4 Press REC PAUSE (or MD P on the
remote).
The MD deck starts recording, and the
CD player starts playing.
To stop recording
Press REC STOP.
When “TOC“ flashes in the display
The MD deck is currently updating the
Table of Contents (TOC).
Do not move the MD deck or pull out the
mains lead. Changes to an MD made
through recording are saved only when
you update the TOC by ejecting the MD or
by pressing POWER to switch the deck to
standby.
Recording from the
Radio
You can record from the tuner onto an MD
(analog recording).
If you use a recorded MD, the MD deck will
automatically start recording from the end
of the existing sound.
1 Press MD § and insert a recordable
MD.
open the slot. To enable recording, close the
slot.
Recording a CD
You can easily make digital recordings
from CD on an MD (CD synchro
recording), marking track numbers in the
same sequence as the original CD. When
you use a blank MD*, the CD name which
you have stored using the “disc memo”
function is also record on the MD
automatically.
When recording additional tracks on a
recordable MD, the MD deck will
automatically start recording from the end
of the existing sound.
* A brand-new MD, or an MD which has been
erased using the “erase function”.
1 Press MD § and insert a recordable
MD.
2 Press CD §, place a CD, then press
CD § again to close the disc tray.
TOC
Slide the tab in the
direction indicated
by the allow
Rear of the disc
Record-protect tab
Label side up
Arrow pointing
toward the MD
deck
Label side up
POWER m ON
4
1
3
2
REC STOP
POWER m ON
6
41
REC
STOP
2
53
continue to next page m
Label side up
Arrow pointing
toward the MD
deck
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony mj l 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony mj l 1 in the language / languages: English, French, Portuguese, Spanish as an attachment in your email.

The manual is 2,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sony mj l 1

Sony mj l 1 User Manual - German, Dutch, Italian - 108 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info