63488
50
Zoom out
Zoom in
Previous page
1/300
Next page
50
Troubleshooting
The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check the
connection and operating procedures.
Depending on the connected monitor, the unit
may take a few seconds to turn off after turning
the ignition off. This is not a malfunction.
General
No power is being supplied to the unit.
• Check the connection. If everything is in order, check
the fuse.
• If the unit is turned off and the display disappears, it
cannot be operated with the remote commander.
tTurn on the unit.
The power antenna (aerial) does not extend.
The power antenna (aerial) does not have a relay box.
No beep sound.
The beep sound is canceled (page 41).
• An optional power amplifier is connected and you are
not using the built-in amplifier.
The contents of the memory have been erased.
• The RESET button has been pressed.
tStore again into the memory.
• The power supply lead or battery has been
disconnected.
• The power supply lead is not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition
is switched.
The leads are not matched correctly with the car’s
accessory power connector.
The display disappears from/does not appear
in the display window.
• The dimmer is set “DIM ON” (page 41).
• The display disappears if you press and hold (OFF).
tPress and hold (OFF) on the unit until the
display appears.
• The connectors are dirty (page 48).
The Auto Off function does not operate.
The unit is turned on. The Auto Off function activates
after turning off the unit.
t Turn off the unit.
Halogenated flame retardants are not used in the
certain printed wiring boards.
Halogenated flame retardants are not used in
cabinets.
Paper is used for the packaging cushions.
VOC (Volatile Organic Compound)-free vegetable
oil based ink is used for printing the carton.
Card remote commander operation is not
possible.
Make sure the insulation film has been removed
(page 12).
Picture
There is no picture/picture noise occurs.
• A connection has not been made correctly.
Check the connection to the connected equipment,
and set the input selector of the equipment to the
source corresponding to this unit.
Defective or dirty disc.
Installation is not correct.
t Install the unit at an angle of less than 45° in a
sturdy part of the car.
• The monitor is connected to the AUDIO/VIDEO
OUT, and the parking cord (light green) is not
connected to the parking brake switch cord, or the
parking brake is not applied.
Picture does not fit in the screen.
The aspect ratio is fixed on the DVD.
Sound
There is no sound/sound skips/sound cracks.
• A connection has not been made correctly.
Check the connection to the connected equipment,
and set the input selector of the equipment to the
source corresponding to this unit.
Defective or dirty disc.
Installation is not correct.
t Install the unit at an angle of less than 45° in a
sturdy part of the car.
The MP3 file sampling rate is not 16, 22.05, 24, 32,
44.1, or 48 kHz.
The WMA file sampling rate is not 32, 44.1, or
48 kHz.
The MP3 file bit rate is not 8 to 384 kbps.
The WMA file bit rate is not 32 to 384 kbps.
The unit is in pause/reverse/fast-forward mode.
The settings for the outputs are not made correctly.
• The DVD output level is too low (page 24).
The volume is too low.
The ATT function is activated.
• The position of the fader control “FAD” is not set for
a 2-speaker system.
The CD changer is incompatible with the disc (MP3/
WMA).
t Play back with this unit.
• Unsupported format (such as DTS).
t Check if the format is supported by this unit
(page 6).
Sound is noisy.
Keep cords and cables away from each other.
• If an Super Audio CD is played and “SUPER AUDIO
CD MODE”/ “SA-CD MOD” is set to “HQ,” instead
set to “STD” (page 39, 42).
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony MEX-DV1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony MEX-DV1000 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 5,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info