460929
14
Zoom out
Zoom in
Previous page
1/36
Next page
14
GB
7: Performing the initial
set-up
1 Connect the TV to your AC power
outlet (mains socket).
2 Press 1 on the TV. The = (power)
indicator will light up in green.
When you switch on the TV for the first
time, the Language menu appears on the
screen.
~
When you turn on the TV for the first time, the
TV requires some internal processing for
optimization before you can perform the
initial setup. There will be no picture and
sound, and the timer indicator on the front of
the TV blinks orange for about 40 seconds. Do
not turn off the TV during this process.
This process has been completed at the factory
for some TVs.
Follow the instructions on the screen.
Satellite Auto Tuning:
The following procedures may be required
depending on the area:
1 Please select “Preferred Satellite” or
“General Satellite”.
2 For “Preferred Satellite”, select your
preferred operator.
“Satellite Auto Tuning” automatically
tunes in available satellite channels. Digital
Satellite Equipment Control (DiSEqC) 1.0
management allows setting of up to four
different channels. The following settings
are independent for each connection. To
set-up DiSEqC input in the “DiSEqC
Control”, use “LNB Configuration”.
1 “Scan Type” and “Advanced Settings”
(for common satellite setting- Satellite 1
to 4):
Allows you to set tuning settings in more
detail to better find the type of services you
would prefer to tune.
“Scan Type”: If no channel is found using
“Network Scan”, try “Full Scan”.
“Full Scan”: Performs a complete
frequency scan and guarantees tuning to
all possible programmes for the currently
set LNB configuration. Previously-tuned
programmes will be lost.
“Network Scan”: Performs a scan in the
transponders of a network (aka NIT
scan). Since “Network Scan” is faster
than “Full Scan”, it is recommended
when tuning to a known network
(normally associated with a satellite). A
transponder must be specified, from
which network information (other
transponders) will be retrieved.
Previously-tuned programmes will be
lost.
2 “LNB Configuration” (for each satellite
setting- Satellite 1 to 4):
In the case of a non-standard LNB (low-
noise block), manual setting is available.
In the case of a single satellite channel,
you can leave it on the initial setting.
For two satellite channels, you need to
set “Toneburst A” (1st satellite) and
“Toneburst B” (2nd satellite) in the
“DiSEqC Control” setting.
3
Except KDL-46/40/
32CX52x
KDL-46/40/32CX52x
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sony KDL-46EX725 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sony KDL-46EX725 in the language / languages: English as an attachment in your email.

The manual is 3,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info